- DL manuals
- Icom
- Transceiver
- IC-F3162DS
- Instruction Manual
Icom IC-F3162DS Instruction Manual
Summary of IC-F3162DS
Page 1
Instruction manual the photo shows the 10-key version uhf transceiver. If4162t/s uhf transceiver if4162dt/ds if3162t/s vhf transceiver if3162dt/ds.
Page 2
I important read all instructions carefully and com- pletely before using the transceiver. Save this instruction manual — this instruction manual contains important operating instructions for the ic-f3162t, ic-f3162s, ic-f3162dt and ic-f3162ds vhf transceivers and ic-f4162t, ic-f4162s, ic- f4162dt a...
Page 3
Ii 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 r caution! Never hold the transceiver so that the antenna is very close to, or touching exposed parts of the body, especially the face or eyes, while transmitting. The transceiver will perform best if the microphone is 5 to 10 cm away from the lips and the t...
Page 4
Iii voice coding technology the ambe+2™ voice coding technology embodied in this product is protected by intellectual property rights including patent rights, copyrights and trade secrets of digital voice systems, inc. This voice coding technology is licensed sole- ly for use within this communicati...
Page 5
Iv table of contents important .......................................................................... I explicit defenitions ..................................................... I precautions .................................................................... Ii voice coding technology ..........
Page 6: Accessories
1 1 accessories ■ supplied accessories the following accessories are supplied. Flexible antenna battery pack belt clip connector cover (with screw) ■ accessory attachments d flexible antenna connect the supplied flexible antenna to the antenna connector. Caution: • never hold the antenna when carryi...
Page 7
2 1 accessories 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 d battery pack to attach the battery pack: slide the battery pack on the back of the transceiver in the direc- tion of the arrow (q), then lock it with the battery release button. • slide the battery pack until the battery release button makes a...
Page 8
3 1 accessories d connector cover attach the connector cover when the optional equipment is not used. To attach the connector cover: q insert the connector cover into the multi-connector. W tighten the screw. Q w multi- connector connector cover caution: attach the connector cover when the optional ...
Page 9: Panel Description
4 2 panel description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ■ front panel w e t r y q !1 !0 o !2 u i microphone speaker q rotary selector rotate to select the pre-programmed memory channels or the operating zone. (depending on the pre-setting) w antenna connector connects the supplied antenna. (p. ...
Page 10: Function Display
!0 multi-connector connect an optional equipment. Connector cover note: attach the connec- tor cover when the optional equipment is not used. See p. 3 for details. !1 busy/transmit indicator ➥ lights green while receiving a signal, or when the squelch is open. ➥ lights red while transmitting. !2 vol...
Page 11: Programmable Function Keys
6 2 panel description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 y bell indicator appears/blinks when the matched signal is received, ac- cording to the pre-programming. U call code memory indicator appears when the call code memory is selected. I battery indicator appears or blinks when the battery pow...
Page 12
7 2 panel description zone key “zone” push this key, then push [ch up] or [ch down] to select the desired zone. When [rotary selector] selects “operating zone,” this key operation is not available. What is “zone”?— selected channels are assigned to a zone according to how they are to be used in a gr...
Page 13
8 2 panel description memory ch 1/2/3/4 keys “ch1” “ch2” “ch3” “ch4” push to select the memory channels 1 to 4 directly. Moni key “mon” ➥ push to mute and release the ctcss (dtcs) or 2-tone squelch mute. Open any squelch/deactivate any mute while pushing and holding this key. (lmr operation only) ➥ ...
Page 14
9 2 panel description talk around key “ta” push to turn the talk around function on and off. • the talk around function equalizes the transmit frequency to the receive frequency for transceiver-to-transceiver communication. Wide/narrow key “w/n” push to toggle the if bandwidth between wide and narro...
Page 15
10 2 panel description tx code channel select key “txc” push to enter the tx code channel selection mode. Then set the desired channel using [ch up]/[ch down]. (pgs. 14, 15) tx code channel up/down keys “txcu” “txcd” push to select a tx code channel directly. Id-memory select key “idms” ➥ recalls de...
Page 16: Turning Power On
■ turning power on prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. (p. 18) q rotate [vol] to turn the power on. W if the transceiver is programmed for a start up password, input the digit codes as directed by your dealer. • 10...
Page 17: Channel Selection
12 3 basic operation ■ channel selection several types of channel selections are available. Methods may differ according to your system set up. Non-zone type: to select the desired operating channel: • push [ch up] or [ch down]. • rotate [rotary selector]*. - up to pre-programmed 16 channels can be ...
Page 18: Call Procedure
■ call procedure when your system employs tone signalling (excluding ctcss and dtcs), this call procedure may be necessary prior to voice transmission. The tone signalling employed may be a selective calling system which allows you to call specific station(s) only and prevent unwanted stations from ...
Page 19
14 3 basic operation d transmitting notes • transmit inhibit function the transceiver has several inhibit functions which restrict transmission under the following conditions: - the channel is in mute condition (‘inaudible’ condition; “ ” (audible indicator) does not appear.) - the channel is busy. ...
Page 20
15 3 basic operation d tx code number edit (pmr operation only) if the transceiver has [tx code ch select] or [tx code enter] assigned to it, tx code contents can be edited within the al- lowable digits. Using [tx code ch select] key: q push [tx code ch select] to enter the tx code channel selection...
Page 21: User Set Mode
16 3 basic operation ■ user set mode user set mode is accessed at power on and allows you to set seldom-changed settings. You can “customize” the transceiver operation to suit your preferences and operating style. Entering the user set mode: q while pushing and holding [p1] and [p2], rotate [vol] to...
Page 22: Scrambler Function
■ scrambler function the voice scrambler function provides private communication between stations. All versions have a built-in frequency inver- sion type scrambler; however, an optional rolling or non-rolling type is available as well. ➥ push [scrambler] to toggle the scrambler function on or off. ...
Page 23: Battery Charging
18 4 battery charging 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ■ caution misuse of lithium-ion batteries may result in the following hazards: smoke, fire, or the battery may rupture. Misuse can also cause damage to the battery or degradation of battery performance. • r danger! Use and charge only spec...
Page 24
• warning! Never put the battery in a microwave oven, high-pressure container, or in an induction heating cooker. This could cause a fire, overheating, or cause the battery to rupture. • caution! Always use the battery within the specified tem- perature range for the transceiver (–25˚c to +55˚c) and...
Page 25: Optional Battery Chargers
20 4 battery charging 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ■ optional battery chargers d rapid charging with the bc-160 the optional bc-160 provides rapid charging of the li-ion battery pack. Charging period: approx. 3 hours (with bp- 232n) the following items are additionally required: • an ac ad...
Page 26
21 4 battery charging d ad-106 installation the ad-106 charger adapter must be installed into the bc-119n or bc-121n before battery charging. ➥ connect the ad-106 charger adapter and the bc- 119n/bc-121n as below, then install the ad-106 into the holder space of the bc-119n or bc-121n with the sup- ...
Page 27
22 4 battery charging 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 d rapid charging with the bc-121n+ad-106 the optional bc-121n allows up to 6 battery packs to be charged simultaneously. Charging period: approx. 3 hours (with bp-232n) the following items are additionally required. • six ad-106 charger ad...
Page 28: Battery Case
■ optional battery case (bp-240) when using the optional battery case attached to the trans- ceiver, install 6 × aaa (lr03) size alkaline batteries as illus- trated at right. Q unhook the battery cover release hook (q), and open the cover in the direction of the arrow (w). (fig.1) w then, install 6 ...
Page 29: Swivel Belt Clip
24 6 swivel belt clip 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ■ mb-93 contents qty. Q belt clip ............................................................................1 w base clip ..........................................................................1 q w ■ to attach q release the battery p...
Page 30: To Detach
■ to detach q turn the transceiver upside down in the direction of the arrow and pull out from the belt clip. W release the battery pack if it is attached. (p. 2) e pinch the clip (q), and slide the base clip in the direction of the arrow (w). Q w caution: hold the transceiver tightly, when hanging ...
Page 31: Speaker Microphone
26 7 speaker microphone 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ■ optional hm-169/170gp description turn the transceiver power off while connecting the hm-169/170gp. Speaker belt clip microphone top key (for hm-170gp only) desired functions can be programmed by your dealer. Gps antenna (for hm-170gp ...
Page 32: Options
27 8 options d battery packs battery pack voltage capacity battery life* 1 bp-230n 7.4 v 950 mah (min.) 980 mah (typ.) 7.35 hrs. Bp-232n 7.4 v 1900 mah (min.) 2000 mah (typ.) 14 hrs. Bp-240 battery case for aaa (lr03) × 6 alkaline —* 2 * 1 when the power save function is turned on, and the operating...
Page 33
28 8 options 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 d dc cables • cp-17l cigarette lighter cable allows charging of the battery pack through a 12 v ciga- rette lighter socket. (for bc-119n) • opc-515l/opc-656 dc power cables allows charging of the battery pack using a 13.8 v power source instead of ...
Page 34
29 8 options d about vs-1sc vox / ptt case the vs-1sc is a vox/ptt unit for icom handheld transceiv- ers, and allows you hands-free operation. An optional headset (hs-94, etc.) is required for operation. • the vox (voice operated transmission) function starts trans- mission without pushing ptt switc...
Page 35
30 8 options 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 • vox delay the vox delay time can be set from 0.5 to 3.0 sec. (0.5 sec. Step) for a convenient interval before returning to receive. 0.5 sec (min.) (default) x txc set cala set txcu txc cala set txcu txc vox dly0.5 vox dly3.0 3.0 sec (max.) x txc ...
Page 36: Doc
31 9 doc ce versions of the ic-f3162t/ic-f3162s/ic- f3162dt/ic-f3162ds and ic-f4162t/ic- f4162s/ic-f4162dt/ic-f4162ds which display the “ce” symbol on the serial number seal, com- ply with the essential requirements of the euro- pean radio and telecommunication terminal directive 1999/5/ec. This war...
Page 37
32 9 doc 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 • list of country codes (iso 3166-1) country codes country codes 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 austria belgium bulgaria croatia czech republic cyprus denmark estonia finland france germany greece hungary iceland ireland italy latvia at be b...
Page 38
Memo.
Page 39
Memo 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16.
Page 40
1-1-32 kamiminami, hirano-ku, osaka 547-0003, japan a-6639h-1eu-r printed in japan © 2008−2009 icom inc. Printed on recycled paper with soy ink. At fi it pl gb ro be fr lv pt is tr cy de lt sk li hr cz gr lu si no dk hu mt es ch ee ie nl se bg.