- DL manuals
- Icom
- Transceiver
- IC-F3262DS
- Instruction Manual
Icom IC-F3262DS Instruction Manual
Summary of IC-F3262DS
Page 1
Instruction manual the photo shows the uhf transceiver. If4262dt if4262ds uhf dpmr handheld transceivers if3262dt if3262ds vhf dpmr handheld transceivers.
Page 2
I important read all instructions carefully and com- pletely before using the transceiver. Save this instruction manual — this instruction manual contains important oper ating instructions for the ic-f3262dt, ic-f3262ds vhf dpmr handheld transceivers and ic-f4262dt, ic-f4262ds uhf dpmr handheld tran...
Page 3
Ii r danger! Never short the terminals of the battery pack. R danger! Use and charge only specified icom battery packs with icom radios or icom chargers. Only icom battery packs are tested and approved for use with icom radios or charged with icom chargers. Using third-party or counterfeit battery p...
Page 4
Iii be careful! The transceiver meets ip67 require- ments for dust-tight and waterproof protection. However, once the transceiver has been dropped, dust-tight and waterproof protection cannot be guaranteed because of possible dam- age to the transceiver’s case or the waterproof seal. Even when the t...
Page 5
Iv 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 table of contents important .......................................................................... I explicit definitions ....................................................... I precautions .................................................................
Page 6: Accessories
1 1 accessories supplied accessories ■ the following accessories are supplied. Battery pack belt clip connector cover (with screw) flexible antenna (this illustration is for the uhf type.) note: some accessories are not supplied, depending on the transceiver version. Accessory attachments ■ flexible...
Page 7
2 1 accessories battery pack d to attach the battery pack: slide the battery pack in the direction of the arrow (q) until the battery release button makes a ‘click’ sound. Note: push on the bottom of the pack to make sure the release button is firmly locked. To remove the battery pack: push the batt...
Page 8
3 1 accessories connector cover d to attach the connector cover: q place the connector cover over the multi-connector. W tighten the screw. Q w multi- connector connector cover caution: attach the connector cover when optional equipment is not used. Otherwise the terminals of the multi-connector may...
Page 9: Panel Description
4 2 panel description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 front panel ■ w e t r y q !1 !0 o !2 u i microphone speaker gps receiver* *a gps receiver is bult-in, depending on the transceiver version. Q rotary selector rotate to select the memory channels or the operating zone, depending on the pres...
Page 10: Function Display
!0 multi-connector connects to optional equipment. Connector cover note: attach the connec- tor cover when optional equipment is not used. See page 3 for details. !1 busy/transmit indicator ➥ lights green while receiving a signal, or when the squelch is open. ➥ lights red while transmitting. !2 volu...
Page 11
6 2 panel description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 r low power icon appears when low output power is selected. • when the battery power decreases to a specified level, low power is automatically selected. T audible icon ➥ appears when the channel is in the ‘audible’ (unmute) mode. ➥ appear...
Page 12: Programmable Function Keys
2 panel description programmable function keys ■ the following functions can be assigned to the [emr], [side1], [side2], [side3], [p0], [p1], [p2] and [p3] program- mable function keys in the normal mode and the shift mode. When [shift] is assigned, you can toggle between normal mode and shift mode,...
Page 13
8 2 panel description priority channel keys “pra” “prb” push to select the priority a or priority b channel. Priority channel (rewrite) keys “prar” “prbr” ➥ push to select the priority a or priority b channel. ➥ hold down [prio a (rewrite)] or [prio b (rewrite)] for 1 second to rewrite the priority ...
Page 14
2 panel description monitor (audible) key “mon” push to mute and release the ctcss (dtcs) or 2/5-tone ➥ squelch mute. Open any squelch or deactivate any mute while holding down this key. (lmr operation only) independently activates one or two of the following func- ➥ tions on each channel. (pmr oper...
Page 15
10 2 panel description tone/cc channel select key “t sel” ➥ while in the analog mode, push to enter the continuous tone selection mode. Then push [ch up] or [ch down] to select the desired tone frequency/code setting. After se- lecting, push this key again to store the setting. ➥ while in the digita...
Page 16
11 2 panel description call keys “call” “cala” “calb” push to transmit a 2/5-tone code or biis/dpmr call. • a call transmission may be necessary before you call another sta- tion, depending on your signalling system. • [call a] and/or [call b] may be selectable when your system employs selective ‘in...
Page 17
12 2 panel description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 scrambler key “scr” push to turn the voice scrambler function on or off. Compander key “comp” push to turn the compander function on or off. The compander function reduces noise components from the transmitted audio to provide clear commu...
Page 18: Turning Power On
Turning power on ■ prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. (p. 23) q rotate [vol] to turn on the power. W if the transceiver is programmed for a start up password, input the digit codes as directed by your dealer. • th...
Page 19: Channel Selection
14 3 basic operation channel selection ■ several types of channel selections are available. Methods may differ, depending on the presetting. Non-zone type: to select the desired operating channel: • push [ch up] or [ch down]. • rotate [rotary selector]*. - up to 16 preprogrammed channels can be sele...
Page 20: Call Procedure
Call procedure ■ when your system employs tone signaling, excluding ctcss and dtcs, this call procedure may be necessary prior to voice transmission. The tone signaling employed may be a selective calling system which allows you to call only specific station(s) and prevents unwanted stations from co...
Page 21
16 3 basic operation transmitting notes d • transmit inhibit function the transceiver has several inhibit functions which restrict transmission under the following conditions: - the channel is muted (‘inaudible’ mode; “ ” (audible icon) does not appear.) - the channel is busy. - unmatched or matched...
Page 22
3 basic operation tx code number edit d (5-tone operation only) if the transceiver has [tx code ch select] or [tx code enter] assigned, the tx code contents can be edited within the allowable digits. Using [tx code ch select] key: q push [tx code ch select] to enter the tx code channel selection mod...
Page 23: User Set Mode
18 3 basic operation user set mode ■ the user set mode allows you to set seldom-changed set- tings and “customize” the transceiver operation to suit your preferences and operating style. Entering the user set mode: q hold down [set] for 1 second to enter the user set mode. W push [set] several times...
Page 24: Emergency Transmission
19 3 basic operation emergency transmission ■ when [emergency] is pushed for the specified time period, an emergency signal is transmitted once, or repeatedly, on the specified emergency channel, depending on the presetting. A repeat emergency signal is automatically transmitted until the transceive...
Page 25: Automatic Key Lock Function
20 3 basic operation 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 automatic key lock function ■ when [lock] is assigned to any key, and the automatic key lock timer is preprogrammed*, the key lock function can be automatically turned on after the specified time period has passed with no key operation. Whi...
Page 26: Caution
Caution ■ misuse of lithium-ion batteries may result in the following hazards: smoke, fire, or the battery may rupture. Misuse can also cause damage to the battery or degradation of battery performance. • r danger! Use and charge only specified icom battery packs with icom radios or icom charger. On...
Page 27
• r warning! Immediately stop using the battery if it emits an abnormal odor, heats up, or is discolored or deformed. If any of these conditions occur, contact your icom dealer or distributor. • r warning! Immediately wash, using clean water, any part of the body that comes into contact with fluid f...
Page 28: Optional Battery Chargers
4 battery charging 23 optional battery chargers ■ rapid charging with the bc-160 d the optional bc-160 provides rapid charging of the li-ion battery pack. Charging time: approximately 3 hours with the bp-232wp the following items are additionally required: • an ac adapter (may be supplied with bc-16...
Page 29
24 4 battery charging 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ad-106 installation d the ad-106 charger adapter must be installed into the bc- 119n or bc-121n before battery charging. Q connect the ad-106 charger adapter and the bc-119n/ bc-121n. W install the ad-106 into the holder space of the bc-11...
Page 30
4 battery charging 25 rapid charging with the bc-121n+ad-106 d the optional bc-121n allows up to 6 battery packs to be si- multaneously charged. Charging time: approximately 3 hours with the bp-232wp the following items are additionally required. (purchase separately) • six ad-106 charger adapters •...
Page 31: Battery Case
26 5 battery case 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 bp-240 optional battery case ■ when using the bp-240 battery case, install six aaa (lr03) size alkaline batteries, as illustrated to the right. Q unhook the battery cover release hook (q), and open the cover in the direction of the arrow (w). ...
Page 32: Bp-261 Optional Battery Case
27 5 battery case bp-261 optional battery case ■ alkaline batteries installation d install six aa (lr6) size alkaline batteries as described below. Unhook the battery cover release hook ( q q ), and open the cover in the direction of the arrow (w). (fig.1) install six aa (lr6) size alkaline batterie...
Page 33
28 5 battery case 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 battery case attachment d slide the battery pack in the direction of the arrow until the battery release button makes a ‘click’ sound. To remove the battery case: slide the battery case’s battery release button in the direction of the arrow (q...
Page 34: Swivel Belt Clip
6 swivel belt clip 29 mb-93 contents ■ qty. Q belt clip ............................................................................1 w base clip ..........................................................................1 q w to attach ■ q remove the battery pack if it is attached. (p. 2) w slide th...
Page 35: To Detach
30 6 swivel belt clip 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 to detach ■ q turn the transceiver upside down in the direction of the arrow and pull it out of the belt clip. W remove the battery pack if it is attached. (p. 2) e pinch the clip (q), and slide the base clip in the direction of the arrow ...
Page 36: Optional Hm-184
Optional hm-184 ■ turn off the trans- ceiver power when at- taching or detaching the microphone. Speaker belt clip microphone ptt switch hold down to transmit; release to receive. Never immerse the connector in water. If the connector becomes wet, be sure to dry it before attaching it to the transce...
Page 37: Options
32 8 options 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 battery packs d • bp-232wp li - ion battery pack voltage: 7.4 v, capacity: 2250 mah (min.) 2300 mah (typ.) • battery life gps unit vhf uhf digital mode analog mode digital mode analog mode built in type 11 hrs. 11.5 hrs. 10.5 hrs. 11 hrs. Non gps t...
Page 38
Antennas d • fa-sc56vs/fa-sc57vs/fa-sc73us stubby antennas shorter vhf or uhf antennas. Fa-sc56vs: frequency range 150–162 mhz fa-sc57vs: frequency range 160–174 mhz fa-sc73us: frequency range 450–490 mhz • fa-sc25v/fa-sc55v/fa-sc03u/ fa-sc25u/fa-sc57u/fa-sc72u flexible antennas vhf or uhf antennas....
Page 39: Country Code List
34 9 country code list 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 • iso 3166-1 country codes country codes 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 austria belgium bulgaria croatia czech republic cyprus denmark estonia finland france germany greece hungary iceland ireland italy latvia at be bg hr cz cy...
Page 40
1-1-32 kamiminami, hirano-ku, osaka 547-0003, japan a-7035d-1eu-0a printed in japan © 2012 icom inc. Printed on recycled paper with soy ink. At fi it pl gb ro be fr lv pt is tr cy de lt sk li hr cz gr lu si no dk hu mt es ch ee ie nl se bg.