1. DL manuals
  2. Icom
  3. Repeater
  4. IC-FR5100
  5. Instruction Manual

Icom IC-FR5100 Instruction Manual

Other manuals for IC-FR5100: Service Manual, Instruction Manual, Instruction Manual
Manual is about: VHF FM

Summary of IC-FR5100

  • Page 1

    Instruction manual vhf dpmr repeater ifr5100 ifr6100 uhf dpmr repeater.

  • Page 2: Features

    I forward thank you for purchasing this icom repeater. The ic-fr5100/ic-fr6100 vhf/uhf d pmr repeaters is designed and built with icom’s state of the art technol- ogy and craftsmanship. With proper care, this product should provide you with years of trouble-free opera- tion. We appreciate you making...

  • Page 3

    Ii precautions r warning high voltage! Never attach an antenna or internal antenna connector during trans- mission. This may result in an electrical shock or burn. R warning high voltage! Never install the antenna at any place that person touch the an- tenna easily during transmission. This may resu...

  • Page 4: Panel Description

    1 panel description 2001 new 1 q internal speaker you can listen to received audio. W volume control [volume] (p. 7) rotate to adjust the audio output level. E selector dial [select] rotate to adjust the squelch threshold level or se- lect the operating channel. (depending on the pre- programmed set...

  • Page 5: Rear Panel

    Q external speaker connector [sp] connect the optional sp-22. W receive antenna connector [rx] connect a receive antenna (impedance: 50 ˘ ) to receive signals. E accessory connector [acc] connects to the accessory connector. • see page 3 for accessory connector information. R dc power receptacle con...

  • Page 6

    3 1 panel description d accessory connector q !3 !4 @5 specification description pin name pin no. Nc txd rxd rts cts nc gnd mod in disc out ext. D/a vcc ext. A/d nc gnd ext.I/o 15 ext.I/o 16 ext.I/o 17 ext.I/o 18 ext.I/o 19 data in ext.I/o 21 af out ext.I/o 23 ext.I/o 24 ext.I/o 25 1 2 3 4 5 6 7 8 9...

  • Page 7: Installation and Connections

    2 4 installation and connections ■ unpacking after unpacking, immediately report any damage to the delivering carrier or dealer. Keep the shipping car- tons. For a description and a diagram of accessory equip- ment included with the repeater, see ‘supplied ac- cessories’ on page ii of this manual. ■...

  • Page 8: Front Panel Connection

    ■ front panel connection p 0 p 1 p 2 p 3 p 4 sm-25 desktop microphone (optional) microphone connector (front panel view) hm-152 hand microphone (optional) q i caution: do not short pin 1 to ground as this can damage the internal 8 v regulator. Dc voltage is applied to pin 1 for microphone operation....

  • Page 9: Power Supply Connection

    6 2 installation and connections ■ power supply connection make sure the repeater’s power switch is turned off when connecting a dc power cable. R warning! Voltages greater than 16 v dc will damage the repeater. Check the source voltage be- fore connecting the power cable. ■ mounting the repeater d ...

  • Page 10: Receiving and Transmitting

    ■ receiving and transmitting d repeater operation ask your dealer for details of the repeater’s program- ming. ➥ when the power is turned on, the [pwr] indicator lights green. (p. 1) ➥ the [tx] and [busy] indicators light simultane- ously while transmitting or receiving a signal. • the [tx] indicato...

  • Page 11: Maintenance

    4 8 maintenance problem possible cause solution ref. ■ troubleshooting the following chart is designed to help correct prob- lems which are not equipment malfunctions. If you are unable to locate the cause of a problem or solve it through the use of this chart, contact the near- est icom dealer or s...

  • Page 12: Options

    5 9 options • sp-22 external speaker compact and easy-to-install. Input impedance : 4 ˘ maximum input power : 5 w • hm-152 hand microphone • sm-25 desktop microphone • ur-fr5100/ur-fr6100 channel extension modules • uc-fr5000 d pmr controller • ut-109r voice scrambler unit non-rolling type (maximum ...

  • Page 13: About Ce

    6 10 about ce installation notes • compliance of base station transmitter installa- tions with en50385 the installation of this equipment and it’s associated antenna should be made in such a manner as to re- spect the ec recommended electromagnetic (em) field exposure limits. (1999/519/ec) in order ...

  • Page 14

    11 6 about ce • typical installation example a uhf base station transmitter is to be installed on the roof of an office. The transmit power is 25 watts, there is 20 m of rg-213 coaxial cable and the antenna is vertically polarised dipole. The specification of the rg-213 cable gives a loss of 1.5 db/...

  • Page 15: Declaration

    12 6 about ce declaration of conformity we icom inc. Japan 1-1-32, kamiminami, hirano-ku osaka 547-0003, japan kind of equipment: uhf repeater type-designation: ic-fr6100/ur-fr6100 signature authorized representative name place and date of issue declare on our sole responsibility that this equipment...

  • Page 16

    1-1-32 kamiminami, hirano-ku, osaka 547-0003, japan at fi it pl gb ro be fr lv pt is tr cy de lt sk li hr cz gr lu si no dk hu mt es ch ee ie nl se bg a-6851h-1eu printed in japan © 2010 icom inc. Printed on recycle paper with soy ink..