- DL manuals
- Icom
- Repeater
- IC-FR5100
- Instruction Manual
Icom IC-FR5100 Instruction Manual
Summary of IC-FR5100
Page 1
Instruction manual ifr6100 uhf dpmr repeater ifr6100h ifr5100 vhf dpmr repeater ifr5100h.
Page 2: Features
I important read this instruction manual carefully before attempting to operate the re- peater. Save this instruction manual– this manual contains important safety and operating in- structions for the ic-fr5100 and ic-fr5100h vhf d pmr repeaters , and the ic-fr6100 and ic-fr6100h uhf d pmr repeaters...
Page 3
Ii precautions r warning high voltage! Never attach an antenna or internal antenna connector while trans- mitting. This may result in an electrical shock or burn. R warning high voltage! Never install the antenna in a place where a person could easily touch the antenna while transmitting. This could...
Page 4: Panel Description
1 1 panel description q internal speaker received audio is heard. W volume control [volume] (p. 8) adjusts the audio output level. E selector dial [select] rotate to adjust the squelch threshold level, or se- lect the operating channel, depending on the pre- programming. R power indicator [power] ➥ ...
Page 5: Rear Panel
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 2 1 panel description q external speaker jack [sp] connects to the optional external speaker. W if signal out connector connects to a dpmr control unit to output an if sig- nal. E receive antenna connector [rx] connects to a 50 ˘ antenna to recei...
Page 6
3 1 panel description d accessory connector q !3 !4 @5 ■ rear panel (continued) pin no. Pin name description specification 1 nc no connection — 2 txd output terminal for serial communication data. — 3 rxd input terminal for serial communication data. — 4 rts output terminal for request-to-send data....
Page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 4 1 panel description d i/o connector (for the pa unit) y o q t pin no. Pin name description specification 1 pa temp output terminal for the pa unit temperature data. — 2 fan alm output terminal for the cooling fan data. H: normal, l: fan stops o...
Page 8: Installation and Connections
2 5 installation and connections ■ unpacking after unpacking, immediately report any damage to the delivering carrier or your dealer. Keep the shipping cartons. For a description and a diagram of accessory equip- ment included with the repeater, see ‘supplied ac- cessories’ on page i of this manual....
Page 9: Front Panel Connection
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 6 2 installation and connections ■ front panel connection ■ rear panel connection— for the ic-fr5100h/ic-fr6100h to [tx] opc-2202 (option) opc-2243 to [acc] to [i/o] to [tx] connects to a dpmr control unit, if used. Connects to a 4 ˘ external spe...
Page 10: Power Supply Connection
7 2 installation and connections ■ power supply connection make sure the repeater’s power is turned off when connecting a dc power cable. Caution: voltages greater than 16 v dc will dam- age the repeater. Check the source voltage before connecting the power cable. ■ mounting the repeater d using the...
Page 11: Operation
3 8 operation 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 ■ receiving and transmitting d repeater operation ask your dealer for details of the repeater’s program- ming. ➥ when the power is turned on, the [pwr] indicator lights green. (p. 1) ➥ the [tx] and [busy] indicators light simultane-...
Page 12: Maintenance
4 9 maintenance ■ troubleshooting the following chart is designed to help correct prob- lems which are not equipment malfunctions. If you are unable to locate the cause of a problem or solve it through the use of this chart, contact the near- est icom dealer or service center. ■ fuse replacement if ...
Page 13: Options
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 5 10 options • sp-22/sp-35 external speakers compact and easy-to-install. Input impedance : 4 ˘ maximum input power : 7 w maximum • hm-152 hand microphone • sm-26 desktop microphone • opc-2202 connection cable connects between the repeater unit a...
Page 14: About Ce
6 11 about ce installation notes • compliance of base station transmitter installa- tions with en50385 the installation of this equipment and it’s associated antenna should be made in such a manner as to re- spect the ec recommended electromagnetic (em) field exposure limits. (1999/519/ec) in order ...
Page 15
12 6 about ce 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 • typical installation example a uhf base station transmitter is to be installed on the roof of an office. The transmit power is 25 watts, there is 20 m of rg- 213 coaxial cable and the antenna is a vertically polar- ised dipole. Th...
Page 16
1-1-32 kamiminami, hirano-ku, osaka 547-0003, japan at fi it pl gb ro be fr lv pt is tr cy de lt sk li hr cz gr lu si no dk hu mt es ch ee ie nl se bg a-7004h-1eu- r printed in japan © 2012–2013 icom inc..
Page 17: Addendum
Addendum the new optional opc-2311 is now available for various connections to a dpmr control unit. ■ rear panel connection for the ic-fr5100/ic-fr6100: caution: never remove the fuse holders from the dc power receptacle. Connects to a 4 ˘ external speaker. Connects to an rx antenna. Connects to a t...