Icom IC-G88 Operating Manual - Section
Section
4
6
SET MODES
User Set mode
Backlight
Select a state of the backlight.
• ON: The backlight turns ON
all the time.
• AUT: When pushing any key
(except [PTT]), the backlight automatically
turns ON for 5 seconds.
• AU2: When changing the displayed contents of the
LCD, the backlight automatically turns ON for
5 seconds.
• OFF: Turns OFF the backlight.
Beep ON/OFF
Turn the key-touch beeps ON or OFF.
• ON: When you push a key,
the beep sounds.
• OFF: The function is OFF, for a
silent operation.
Beep Level
Set the beep and announce
output level. When you select
a Linked option, the beep level
can be adjusted by
[VOL].
• 1 (minimum) – 5 (maximum)
• 1 (minimum) – 5 (maximum)
: Linked with the audio level. Rotate
[VOL] to ad-
just the beep level.
Ringer Level
Set the ringer level. When you
select a Linked option, the
ringer level can be adjusted by
rotating [VOL].
• 1 (minimum) – 5 (maximum)
• 1 (minimum) – 5 (maximum)
: Linked with the audio level. Rotate
[VOL] to ad-
just the ringer level.
SQL (Squelch) Level
Sets the SQL level. The
squelch function suppresses
the noise output from a speaker
when no signal is received.
• 0: SQL Open
• 2: SQL Threshold
• 9: SQL Tight
AF Min Level (Minimum audio output level)
Sets the minimum audio output
level. This function determines
the minimum audio output level
not to let the audio level be-
come lower than the set level.
• 0 (minimum) ~ 255 (maximum)
Mic Gain
Sets the microphone sensitivity.
Higher values make the micro-
phone more sensitive to the
user's voice.
• 1 (minimum) ~ 4 (maximum)
Battery Voltage Display
Select whether or not to display
the battery voltage, when turn-
ing ON the transceiver.
• ON:
Displays the battery voltage for 2 seconds.
• OFF: Does not display the battery voltage.
Signal Moni
Select whether or not to release
the mute while using a DTMF
code signaling.
• ON: The mute is released
while transmitting a DTMF Code.
• OFF: The mute is not released while transmitting a
DTMF Code.
The are 2 Set modes: User Set mode and VFO Set mode.
NOTE:
Beep: Any sound except ringers.
Ringer: Sounds when receiving a call.
The User Set mode enables you to change various settings. You can “customize” the transceiver operation to suit
your preferences and operating style.
Entering the User Set mode:
➥
Hold down
[VFO / User Set Mode] for 1 second to
enter the User Set mode.
• While in the User Set mode, push
[VFO / User Set Mode]
again to select an item, and then change the value or
setting by pushing
[UP] or [DOWN].
Exiting the User Set mode:
➥
Hold down
[VFO / User Set Mode] again to exit the
User Set mode.