Icom VE-PG3 Installation Instructions Manual

PRECAUTIONS

■ For the AC adapter

R WARNING! NEVER use other than the VE-PG3. This 

may result in an electrical shock, cause a fire or damage 

the AC adapter.

R WARNING!  Connect the adapter into an outlet 

between 100 V and 240 V AC. Otherwise, this may result in 

an electrical shock, cause a fire or damage the AC adapter.

R WARNING! NEVER install the AC adapter to wet place 

where is outside or near the humidifier. This may result in an 

electrical shock, cause a fire or damage the AC adapter.

R WARNING! NEVER put something heavy on the AC 

adapter cable. This may result in an electrical shock,  cause 

a fire or damage the AC adapter.

R WARNING! NEVER modify, bend by force, twist, 

pull or heat the AC adapter’s cable. This may result in an 

electrical shock, cause a fire or damage the AC adapter.

R WARNING! NEVER  touch the AC adapter with wet 

hands. This may result in an electrical shock or damage the 

AC adapter.

R WARNING! NEVER use the AC adapter when it can 

not closely insert into the AC outlet. This may result in an 

electrical shock, cause a fire or damage the AC adapter.

R WARNING!  Use and place the AC adapter and 

connection cable to avoid inadvertent use by children. This 

may result in an electrical shock or 

cause injury.

■ Other precautions

•  When operating the PC or external device, see those 

instruction manuals for details.

•  The supplied AC adapter may at some time need to be 

replaced, depending on its life expectancy. The life of 

an AC adaptor differs according to the environment or 

condition in which the adaptor is used. 

   We recommend replacement when it has been used for 

approximately 5 years (When used under the ambient 

temperature of 25 °C; 77°F). Contact your local dealer for 

details.

• VE-PG3 supports only IPv4. IPv6 is not supported.

FCC INFORMATION

CAUTION:  Any changes or modifications not expressly 

approved by the party responsible for 

compliance could void the user’s authority 

to operate the equipment.

NOTE: 

This equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to part 15 

of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and 

can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more 

of the following measures:

 • Reorient or relocate the receiving antenna.

 •  Increase the separation between the equipment and 

receiver.

 •  Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected.

 •  Consult the dealer or an experienced radio/TV technician 

for help.

ABOUT CE

This equipment complies with the essential 

requirements of the 2004/108/EC directive for 

Electromagnetic Compatibility.

■ For the VE-PG3

R WARNING! NEVER use other than the specified AC 

adapter. This may result in an electrical shock, cause a fire 

or damage the VE-PG3.

R WARNING! NEVER use non-specified accessories or 

options. This may result in an electrical shock, cause a fire 

or damage the VE-PG3.

R WARNING! NEVER connect the AC adapter to other 

than the [DC] jack on the VE-PG3 rear panel. This may 

result in an electrical shock, cause a fire or damage the 

VE-PG3.

R WARNING! NEVER disassemble, modify or repair the 

VE-PG3. This may result in an electrical shock, cause a fire 

or damage the VE-PG3.

R WARNING! NEVER install the VE-PG3 in a wet place 

or outside. This may result in an electrical shock, cause a 

fire or damage the VE-PG3.

R WARNING! NEVER operate or touch the VE-PG3 with 

wet hands. This may result in an electrical shock or damage 

the VE-PG3.

R WARNING! NEVER connect the ground terminal to a 

gas or electric pipe. This may result in an electrical shock or 

cause a fire.

R WARNING! NEVER use the VE-PG3 during a thunder 

and lightening storm. Using it may result in an electrical 

shock, cause a fire or damage the VE-PG3. Always 

disconnect the AC adapter before any storm.

R WARNING!  Immediately disconnect the AC adapter 

if the VE-PG3 emits an abnormal odor, sound or smoke. 

Contact your Icom dealer or distributor for advice.

CAUTION: NEVER put the VE-PG3 in any unstable place 

(such as on a slanted surface or vibrated place). This may 

cause injury and/or damage to the VE-PG3. 

CAUTION: NEVER  install the VE-PG3 in  a place without 

air vents. Heat dissipation may be reduced, and this could 

damage the VE-PG3.

CAUTION: Always place the VE-PG3 in a secure place to 

avoid inadvertent use by children.

CAUTION: DO NOT use or place the VE-PG3 in areas 

with temperatures below 0

ç (+32ƒ) or above +40ç 

(+104

ƒ).

CAUTION: DO NOT place the VE-PG3 in direct sunlight. 

This could damage the VE-PG3.

CAUTION: DO NOT  use the VE-PG3 in strong magnetic 

fields or in an area with high static electricity. This could 

damage the VE-PG3.

CAUTION: Disconnect the AC adapter when you will not 

use the VE-PG3 for a long period of time.

CAUTION: DO NOT use harsh solvents such as benzine 

or alcohol to clean the VE-PG3, as they can damage the 

VE-PG3’s surfaces. If the VE-PG3 becomes dusty or dirty, 

wipe it clean with a dry, soft cloth.

CAUTION:  Use only the specified cable to connect a 

transceiver or repeater to the VE-PG3. Using another cable 

could cause damage to the VE-PG3 or to the transceiver or 

repeater.

PRECAUTIONS

ABOUT THE OPTIONAL CONNECTION CABLE

PRECAUTIONS

Thank you for purchasing this Icom product. The VE-PG3 

RoIP GATEWAY is designed and built with Icom’s IP 

network technology. We hope you agree with Icom’s 

philosophy of “technology first.” Many hours of research 

and development went into the design of your VE-PG3.

IMPORTANT

READ ALL INSTRUCTIONS carefullyand completely 

before using the VE-PG3.

SAVE THESE  INSTRUCTIONS

  — 

These instructions 

contain important safety and operating instructions for the 

VE-PG3.

EXPLICIT DEFINITIONS

WORD

DEFINITION

RWARNING!

Personal injury, fire hazard or electric 

shock may occur.

CAUTION

Equipment damage may occur.

NOTE

If disregarded, inconvenience only. No risk 

of personal injury, fi re or electric shock.

Before connecting cables, see the cable's manual and the 

sticker on the bottom of the VE-PG3 for port information.

•  Verify that both the VE-PG3 and connected devices are 

turned OFF when connecting or disconnecting the cable.

•  H o l d   t h e   c o n n e c t o r   b o d y   w h e n   c o n n e c t i n g   o r 

disconnecting them.

•  When other cables are connected, you can use needle-

nose pliers to carefully insert or remove connectors.

• Never bend or pinch the cable.

 • Never place a heavy object on the cable.

• Never touch the cable with wet hands.

•  Always connect the cable correctly. An incorrect connection 

could damage the VE-PG3 and/or the transceiver.

VE-PG3 

（bottom view）

Connection cable 

（optional）

Port information on the sticker

Sticker

A

B

RoIP GATEWAY