ICON Health & Fitness CTTL078040 User Manual - page 7
7
3. Have the other person hold the Pulse Bar (76) near the
Right Upright (69). Remove the band securing the Pulse
Wire (107) to the Right Upright, and connect the Pulse
Wire to the wire in the Pulse Bar.
The connectors should
slide together easily and snap into place; if they do
not, turn one connector and try again. Insert the wires
into the left side of the Right Upright.
Hold the Pulse Bar (76) against the Right Upright (69) and
the Left Upright (not shown) with the pulse plates up as
shown. Attach the Pulse Bar with two Pulse Bar Bolts (78)
(only one side is shown).
Be careful not to pinch the
wires. Do not tighten the Pulse Bar Bolts yet.
Hold the Crossbar (69) against the Right Upright (69) and
the Left Upright (not shown). Attach the Crossbar with two
Crossbar Bolts (77).
Do not tighten the Crossbar Bolts
yet.
68
Pulse
Plates
78
77
107
69
3
76
107
4. Have a second person hold the console assembly near the
Right Upright (69). Connect the Upright Wire Harness (98)
and the Pulse Wire (107) to the wires extending from the
console assembly.
The connectors should slide together
easily and snap into place. If they do not, turn one con-
nector and try again. Insert the connectors into the Right
Upright.
Connect the Upright Ground Wire (41) to the ground wire
extending from the console assembly.
Make sure that
the wires are fully connected to each other. Insert the
ground wires into the console assembly.
69
107
Console
Assembly
Ground
Wire
98
41
4
107
98
2. W ith the help of a second person, raise the Left Upright
(64) and the Right Upright (not shown) to a vertical posi-
tion. Raise the Frame (105) to a vertical position.
Press the indicated end of the Shock (105) onto the
bracket on the Base (49) as shown. Press the other end
of the Shock onto the bracket on the Frame (12). Note: It
may be necessary to move the Frame forward or back-
ward to align the Shock with the bracket. It may be help-
ful to use a flat head screwdriver (see the inset drawing)
to lift the metal clip on the Shock as you press the Shock
onto the bracket.
Do not remove the clip.
Carefully lower the Frame (12).
105
49
69
2
12
105
Clip