Serial number decal caution read all precautions and instructions in this manual before using this equipment. Keep this manual for future reference. Model no. Wlex61115c.0 serial no. Write the serial number in the space above for reference. User’s manual weslo.Com to register your product and activa...
2 table of contents warning decal placement warning decal placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 important precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
3 warning: to reduce the risk of serious injury, read all important precautions and instructions in this manual and all warnings on your exercise bike before using your exercise bike. Icon assumes no responsibility for personal injury or property damage sustained by or through the use of this produc...
4.
5 seat resistance knob seat handlebar *water bottle is not included water bottle holder* pedal/strap leveling cap console handlebar backrest thank you for selecting the weslo ® pursuit g 3.1 exercise bike. The pursuit g 3.1 exercise bike provides a selection of features designed to make your workout...
6 m10 x 65mm bolt (28)–2 m8 x 55mm screw (46)–2 m8 x 80mm bolt (39)–2 m8 x 20mm screw (40)–7 m6 x 20mm screw (47)–4 m6 x 40mm screw (44)–4 m10 locknut (45)–2 m8 locknut (35)–2 m4 x 19mm screw (27)–2 m4 x 13mm screw (42)–4 part identification chart use the drawings below to identify the small parts n...
7 • assembly requires two persons. • place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you complete all assembly steps. • left parts are marked “l” or “left” and right parts are marked “r” or “right.” • to identify small parts, see page...
8 3 3. Attach the seat frame (2) to the frame (1) with four m8 x 20mm screws (40); start all the screws, and then tighten them. 2 1 40 4. Orient the seat carriage (4) and the handlebar (5) as shown. Attach the handlebar (5) to the seat carriage (4) with two m8 x 80mm bolts (39) and two m8 locknuts (...
9 6. Insert the pin on the underside of the seat carriage (4) into the desired adjustment hole in the seat frame (2). Attach the seat carriage (4) to the seat frame (2) with the carriage plate (31) and two m8 x 55mm screws (46). 6 31 4 2 46 7 7. Attach the backrest (7) to the seat carriage (4) with ...
10 9 40 40 49 33 3 a a 1 9. Have a second person hold the upright (3) near the frame (1). Locate the wire tie (a) in the upright (3). Tie the lower end of the wire tie to the reed switch wire (33). Next, pull the upper end of the wire tie until the reed switch wire is routed through the upright. Tip...
11 12 3 12 c d 24 33 42 11. Untie and discard the wire tie on the reed switch wire (33). While a second person holds the console (8) near the upright (3), connect the wire on the console to the reed switch wire (33). Insert the excess wire into the upright (3) or into the console (8). Tip: avoid pin...
12 how to adjust the seat the seat can be adjusted forward or backward to the position that is the most comfortable for you. To adjust the seat, first remove the two indicated screws (a) and the carriage plate (b) from the seat frame (c) and the seat carriage (d). Next, insert the pin on the undersi...
13 console diagram features of the console the easy-to-use console features five modes that provide instant exercise feedback during your workouts. Scan (scan)—this mode displays the time, speed, distance, and calories modes, for a few seconds each, in a repeating cycle. Time (tmr)—this mode display...
14 how to use the console make sure that batteries (not included) are installed in the console (see assembly step 10 on page 10). If there is a sheet of plastic on the console, remove the plastic. 1. Turn on the console. To turn on the console, press any button on the console or simply begin pedalin...
15 maintenance regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the exercise bike is used. Replace any worn parts immediately. To clean the exercise bike, use a damp cloth and a small amount of mild soap. Important: to avoi...
16 how to adjust the drive belt if the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the pedals, the resistance knob, and the shields. Using an adjustable wrench, tur...
17 exercise guidelines these guidelines will help you to plan your exercise program. For detailed exercise information, obtain a reputable book or consult your physician. Remember, proper nutrition and adequate rest are essential for successful results. Exercise intensity whether your goal is to bur...
18 key no. Qty. Description key no. Qty. Description part list model no. Wlex61115c.0 r0617a note: specifications are subject to change without notice.For information about ordering replacement parts, see the back cover of this manual. *these parts are not illustrated. 1 1 frame 2 1 seat frame 3 1 u...
19 30 6 10 12 5 2 4 7 9 11 14 16 18 18 50 50 15 17 17 20 20 21 21 23 30 32 32 22 24 29 36 41 29 31 34 33 40 27 43 43 46 44 39 37 37 45 45 28 47 38 38 27 27 27 27 27 26 25 1 3 8 19 19 13 20 20 40 40 42 27 49 28 35 48 23 exploded drawing model no. Wlex61115c.0 r0617a.
Part no. 392630 r0617a printed in china © 2017 icon health & fitness, inc. To order replacement parts, please see the front cover of this manual. To help us assist you, be prepared to provide the following information when contacting us: • the model number and serial number of the product (see the f...
