ICON Health & Fitness Weslo pursuit g 3.1 User Manual - page 11
11
12
3
12
C
D
24
33
42
11. Untie and discard the wire tie on the Reed
Switch Wire (33).
While a second person holds the Console (8)
near the Upright (3), connect the wire on the
Console to the Reed Switch Wire (33).
Insert the excess wire into the Upright (3) or into
the Console (8).
Tip: Avoid pinching the wires. Attach
the Console (8) to the Upright (3) with four
M4 x 13mm Screws (42); start all the Screws,
and then tighten them.
12. Identify the Right Pedal (12). Using an adjust-
able wrench, firmly tighten the Right Pedal
clockwise into the right side of the Crank (24).
Firmly tighten the Left Pedal (not shown)
counterclockwise into the side of the Crank
(not shown). IMPORTANT: You must turn the
Left Pedal counterclockwise to attach it.
Adjust the strap (C) on the Right Pedal (12) to
the desired position, and press the end of the
strap onto the tab (D) on the Right Pedal. Adjust
the strap on the Left Pedal (not shown) in the
same way.
13. After the exercise bike is assembled, inspect it to make sure that it is assembled correctly and that it
functions properly. Make sure that all parts are properly tightened before you use the exercise bike.
Extra parts may be included. Place a mat beneath the exercise bike to protect the floor.
11
Avoid pinching
the wires
8