ICON Health & Fitness WESLO VECTOR 402 User Manual - page 5
5
12
3
53
42
15
13
3. Slide the two slots in the Handlebar Clamp (42) onto the
two indicated tabs on the Upright (13). Lift the bottom of
the Handlebar Clamp away from the Upright. Insert the
Handlebar (15) between the Handlebar Clamp and the
Upright. Centre the Handlebar and rotate it to the desired
position.
Tighten the Adjustment Handle (53) onto the Upright
(13). Note: The adjustment handle works like a span-
ner. Turn the Handle counterclockwise, pull it away from
the Upright, turn it clockwise, push it toward the upright,
and then turn it counterclockwise again.
4
4. The Console (16) requires three “AA” batteries; alka-
line batteries are recommended. Insert three batteries
into the Console. Make sure that the batteries are
oriented as shown by the diagram inside the
Console.
16
Batteries
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, refer
to step 5 on page 5 and remove the console from the
handlebar. Next, refer to step 4 on page 5 and insert
three batteries into the console. Reattach the console
to the handlebar, being careful not to pinch the wires.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the left side shield must be removed.
Turn the Crank (21) to the position shown. Using an
adjustable spanner, turn the Left Pedal (24) clockwise
and remove it. Next, remove the five M4 x 25mm
Screws (52) and the M4 x 19mm Screw (54) from the
Left Side Shield (17). Carefully remove the Left Side
Shield.
Next, locate the Reed Switch (43). Turn the Crank
(21) until the Magnet (38) is aligned with the Reed
Switch. Loosen, but do not remove, the M4 x 12mm
Screw (46). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the left side shield and the
left pedal.
PULSE SENSOR TROUBLESHOOTING
Refer to step 3 on page 10.
MAINTENANCE AND TROUBLESHOOTING
52
54
17
21
38
43
52
24
21
5. Hold the Console (16) near the Upright (13). Connect
the ground wire to the Upright with the Ground Screw
(27). Next, connect the console wire to the Upper Wire
(36). Insert the excess wire into the Upright. Insert the
console cable into the Upright and push it through the
Upright.
Attach the Console (16) to the Upright (13) with four
M5 x 12mm Screws (49). Be careful to avoid pinch-
ing the wires.
16
5
Be careful to
avoid pinching
the wires.
13
36
49
49
27
Ground
Wire
Console
Wire
Console
Cable
46
Hole