Iconic i2015 CNC Owner's Manual - page 18
Using On-Board SD Card Storage
To avoid accidental USB disconnection during operation, users may choose to transfer
their G-Code files from the USB Stick to the Onboard SD Card.
1.
Plug in your USB Stick, which contains your G-Code files. Turn on machine’s power. A
welcome message will appear on the LCD Screen; press the Enter key on your Keypad,
which will move the Spindle to its default Home Position.Handheld controller will ask
you to confirm that there is a USB Stick inserted. Press Enter to continue.
2.
The LCD screen will display the Main Menu. Move the cursor to Select File, and press
Enter to browse the files located on your USB Stick.
3.
Locate the desired file, and press the Y+ key to save the file to the SD Card.
4.
Upon completion, move the cursor to Configuration, and press Enter, followed by
System Setting.
5.
Move the cursor to Disk:USB, and press Enter. The cursor will become a solid block,
indicating that this option has been selected; press the Down button to change to
Disk:SD.
6.
Press Back to confirm selection, and move the cursor down to select Save. Press Enter
to save these settings.
7.
USB Stick can be safely removed.
8.
Move the cursor to Select File, and press Enter to browse the files located on the SD
Card. To delete these files, simply move the cursor to the appropriate file name, and
press the Y- key to delete.
Repeating Position Of Origin Setting
When carving the same project multiple times, users may choose to re-use a Position of
Origin, rather than manually setting it each time. There are two options available.
1.
From the Main Menu on your handheld controller, select Configuration, followed by
Reset To Origin. Select Work Coordinate. The LCD will display the last-used Position
of Origin. Press Enter To Continue to repeat the origin setting. (Selecting Machine
Coordinate within this menu will reset the machine to its default Position of Origin.)
2.
From the Main Menu on your handheld controller, select Position, followed by
Coordinate Mode. Select the desired Axis to adjust, and press Enter. The cursor will
turn to a solid block, indicating that it is ready to set its coordinates. Press the Up/Down
keys to input the coordinate setting. Once completed, press Back, and select Move and
Set ORG.
i2015 OWNER’S MANUAL
of
18
35