Intergraph Intense 3D Pro 2200 Installation Manual - Installing The Software
9
4
Installing the Software
Refer to the Microsoft Windows NT documentation and online Help
for more information on installing drivers and software application
programs, and configuring your computer’s video display.
Install the Intense 3D Pro 2200 Video Display Driver
To install the Intense 3D Pro 2200 video display driver:
1. Insert the diskette containing the video display driver into the
computer’s floppy disk drive.
CAUTION
Make sure you have the correct driver to use with the Windows NT
4.0 operating system. If you are unsure, refer to the
README
.
TXT
file on the driver diskette for this information.
2. Log on to Windows NT using an account that has administrative
privileges.
3. In the Windows NT Control Panel, open Display to view the
Display Properties dialog.
4. Click Settings (tab), then click Display Type, and then click
Change. The Change Display dialog displays.
5. Click Have Disk. The Install From Disk dialog displays.
6. Type the driver path name (for example, a:\ ), and then click OK.
7. Verify that the Intergraph Intense 3D driver is highlighted in the
Change Display dialog, and then click OK.
8. Click Yes when asked if you want to install a third-party driver.
The driver files are then copied from the diskette to your
computer’s hard drive.
9. After the driver files are successfully copied, a message displays
and states that the driver successfully installed. Click OK.
10. Click Close to exit the Display Type dialog.
11. Click Close to exit the Display Properties dialog.
12. When informed that the computer must be restarted for the new
settings to take effect, remove the diskette from the floppy disk
drive and click Yes to restart the computer.
13. After the system restarts and you log in, a message displays. The
message states that a new graphic driver has been installed, and