Intergraph Intense 3D Pro 3600 Installation Manual - page 11
7
If a computer monitor has no built-in video cable, use a shielded
video cable with a 15-pin (D-sub) video connector at one end for
the video output port on the card, and the appropriate connectors
at the other end for the video input port on the computer monitor.
NOTE
Monitor input ports are usually D-sub or Bayonet Nut Connect
(BNC) connectors. Shielded cables usually have a ferrite core (a
box- or cylinder-shaped attachment) near each end to reduce
interference with radio frequencies.
NOTE
When you start the system and log onto a system with multiple
screens, you may have to switch the cable connections to the
Intense 3D Pro 3600 cards if the screen display is not correct. For
example, in a side-by-side monitor configuration, if the right half of
the Windows NT desktop displays on the left screen, and the left
half of the desktop displays on the right screen, switch the cable
connections to the Intense 3D Pro 3600 cards.
3. If you want to use a stereoscopic display device, connect the
controller’s stereo sync cable to the stereo sync output port on the
card. See the previous figure.
4. Turn on the computer. The video display starts in VGA mode.
5. Install the Intense 3D Pro video display driver as instructed in
Chapter 4, “Installing the Software.”
Video Output
Port (blue)
Stereo Sync
Output Port