Intermec 3400 Instruction Sheet

Manual is about: bar code

Page of 2

Download

Bookmark us

3400

Parallel I/O

Adapter

Card

Use the following instructions to install a 3400

Parallel I/O Adapter Card into a 3400 printer. This

procedure must be performed only by trained service

personnel.

Parts Provided:

• Parallel I/O Adapter Card

• Ribbon cable

Tools Required:

• Phillips screwdriver

Step 1

Removing the I/O Board Port Cover

1. Switch off the printer power and remove the power

cord from the printer.

2. Remove the media cover and the electronics cover

from the printer.

3. Remove and discard the optional I/O board port

cover from the rear of the printer. Retain the

two screws.

Instruction

Sheet

3400-72

Optional I/O

Board Port

Retain the

two screws.

Optional

I/O Board

Port Cover

(Remove and discard.)

Page 1
3400 parallel i/o adapter card use the following instructions to install a 3400 parallel i/o adapter card into a 3400 printer. This procedure must be performed only by trained service personnel. Parts provided: • parallel i/o adapter card • ribbon cable tools required: • phillips screwdriver step 1 ...
Page 2: Intermec
Step 2 installing the parallel i/o adapter card 1. Connect one end of the ribbon cable to j2 on the parallel i/o adapter card. Note: both ends of the ribbon cable are keyed. Either end can be plugged onto the parallel i/o adapter card or the main pcb. 2. With the component side of the parallel i/o a...