Intermec 5020 Installation Manual - page 10
5020 Vehicle Mounting Bracket Installation Guide
10
Connecting the Serial Cable
To connect to a PC, you need the serial cable accessory (Part No. 070268) (sold
separately).
To connect to a printer, you need a compatible 9-pin RS-232 serial cable (not included).
The following table lists the pin assignments for the port on the serial communications
adapter. You can use this table to determine if your printer cable is compatible.
Pin
Signal
Direction From 5020
1
Not Supported (NC)
2
Received Data (RX)
Incoming
3
Transmitted Data (TX)
Outgoing
4
Data Terminal Ready (DTR)
Outgoing
5
Ground (GND)
6
Data Set Ready (DSR)
Incoming
7
Request to Send (RTS)
Outgoing
8
Clear to Send (CTS)
Incoming
9
Not Supported (NC)
If you are connecting to a device that uses Windows CE Services or ActiveSync, you
must use Part No. 070268.
To connect the serial cable to the serial communications adapter
1.
Attach the serial cable to your serial device.
2.
Connect the other end of the cable to the serial communications adapter.