Intermec 5020 Installation Manual - page 4
5020 Vehicle Mounting Bracket Installation Guide
4
To install your 5020 vehicle mounting bracket
1.
Install the adapter plate on a mounting surface.
2.
Attach the 5020 mounting bracket to the adapter plate.
3.
Connect the cables (powered kit only).
4.
Insert the 5020 in the vehicle mounting bracket.
Each step is described in detail in the next sections.
Installing the Adapter Plate
The adapter plate has an angled surface so that it can be oriented to accommodate
vertical or horizontal installation. You can attach the adapter plate directly to a surface,
or you can attach it to the swivel stand accessory (Part No. 070803) (sold separately). If
you have the swivel stand accessory, start on page 6.
To attach the adapter plate to a vertical or horizontal surface
1.
Orient the adapter plate as follows:
•
If you are attaching the mounting bracket to a vertical surface, position the
adapter plate as shown.
5020G003.eps
Adapter
plate
5020 mounting
bracket