Intermec CN2 Instructions

Adjust handstrap

for snug fit

before folding

You are now ready to use your CN2 and handstrap. For help, see the 

CN2 Handheld Computer User’s Manual (P/N 075464). 

6001 36th Avenue West

Everett, Washington  98203

U.S.A.

tel 425.348.2600

fax 425.355.9551

www.intermec.com

©

 2005 Intermec Technologies

Corporation. All rights reserved.

CN2 Handstrap Instructions 

*075465-002* 

P/N 075465-002 

CN2 Handstrap Instructions 

The CN2 Handstrap (P/N 075400) gives you a convenient way to hold 

the CN2 Handheld Computer. Simply place your hand under the 

adjustable nylon strap and grasp the computer. When you use the CN2 

for an extended period of time, the handstrap helps relieve hand stress.  

This instruction sheet lists the parts contained in the handstrap kit and 

describes how to install the handstrap.  

Unpacking the Handstrap Kit 

The handstrap kit contains this instruction sheet and these parts: 

Adjustable

nylon strap

New battery

door

Screws (2)

Upper retaining

bar

Contents of the Handstrap Kit: When you unpack the handstrap kit, the upper 

retaining bar may be attached to the nylon strap, and the screws may be 

magnetically attached to the battery door. 

Make sure you have all these parts. Contact your Intermec 

representative if anything is missing or damaged. 

Installing the Handstrap 

Follow these instructions to install the handstrap. You will need a small 

Phillips screwdriver. 

To install the handstrap 

1 

Turn off the CN2, and place the CN2 face-down on a clean, flat, 

stable surface. 

2 

Using the screws that came with the handstrap, attach the upper 

retaining bar to the CN2.