Intermec Trakker Antares 2430 Quick Start Manual - page 13
C d 39 nuggetfont
Trakker Antares 243X Handheld Terminal Quick Start Guide
13
address must be in the form n.n.n.n, where each n is a
number from 0 to 255. You must separate each n by a period.
(TCP/IP) In the Host IP Address field, enter the IP address
of the host that you want the terminal to communicate with.
The IP address must be in the form n.n.n.n, where each n is a
number from 0 to 255. You must separate each n by a period.
3
In the Terminal IP Address field, enter the IP address of the
terminal. The IP address must be in the form n.n.n.n, where
each n is a number from 0 to 255. You must separate each n
by a period.
If you are using a DHCP (Dynamic Host Configuration
Protocol) server, you can leave the default terminal IP address
as 0.0.0.0 to enable the 2435 as a DHCP client. For help, see
“DHCP (Terminal)” in the 2400 Family system manual.
To configure the Advanced Network parameters
Note: If the Intermec Gateway, DCS 30X, or host is
on a different subnetwork from the terminal, you
need to configure the subnet mask and the default
router.
1
In the Subnet Mask field, enter the mask that is used to
separate the subnetwork address from the terminal IP address.
The subnet mask must be in the form n.n.n.n, where each n is
either 0 or 255. You must separate each n by a period.
2
In the Default Router field, enter the IP address of the
default router. The IP address must be in the form n.n.n.n,
where each n is a number from 0 to 255. You must separate
each n by a period.
(2435 Only) Configure the Radio Parameters
The 2435 communicates with a host computer in an RF
network either through access points and the Intermec Gateway
or DCS 30X or directly through the access points. All RF
devices that communicate with each other must contain the
same radios. The terminal ships with one of these radio options:
WLI Forum OpenAir or IEEE 802.11b.