- DL manuals
- J. A. Roby
- Stove
- ultimate 2015
- Instruction Manual
J. A. Roby ultimate 2015 Instruction Manual
Summary of ultimate 2015
Page 1
Ultimate 2015 can /ulc s627-00 ul 1482-2011 can/csa std b415.1-10 instruction manual 490, rue de l'argon québec, canada g2n 2c9 tél.: 418-849-8095 fax : 418-849-0077.
Page 2
1. Table of content 1. Introduction ...................................................................... 3 2. Nameplate. ...................................................................... 4 3. Appliance dimension. ...................................................... 5 4. Specifications. .......
Page 3: 1. Introduction
3 1. Introduction read all instructions carefully before install your new j.A. Roby stove. A good installation is very important for a safe and effective use of j.A. Roby inc stove. In the doubt about the instruction step to install your appliance correctly, we suggest to call a professional master ...
Page 4: 2. Nameplate.
4 2. Nameplate..
Page 5: 3. Appliance Dimension.
5 3. Appliance dimension. 4. Specifications. Option ultimate 2015 magnum combustible wood wood recommended surface area 3800 ft² 3800 ft² capacity 120 000 btu/h 120 000 btu/h flue pipe diameter 6 inches 15.4 cm 6 inches minimal chimney height 12 feet 365 cm 12 feet 365 cm exterior height 37 13/16 in...
Page 6: 5. Installation.
6 5. Installation. Floor protection. Your stove must be installed on a non-combustible material plate to protect the floor and avoid fire would be caused by: • projections of sparks when door opening or loading logs • the heat radiation when stove runaway should have an ignition to the floor and the...
Page 7
7 minimums clearances to combustible material. With these reduced clearances, this appliance take a minimum of space where is installed. Whether in the living room or the dining room, the cook stove will complete your decorate by his originality and heating, it requires a minimum clearance of 10 inc...
Page 8
8 assembly before installation according to chosen option, to save more storage space and shipping. The stove leg couldn’t be assembled in the shop, you must assembly before install the cooker stove. Legs installation. 1) remove legs and bricks from combustion chamber to lighten the stove. 2) unscre...
Page 9
9 firebricks installation. Floor firebricks installation. 1) put 4 bricks «a» in the bottom like the picture. 2) after, insert 5 bricks «a» in front the 4 bricks previously placed. 3) insert 2 brick «a» each side of the pilot. 4) insert brick «a» and «b» to finish under the door. Back firebricks ins...
Page 10
10 3) add two horizontal bricks «a» above de 5 previously placed. 4) to finish, put the slotted washer and tighten the 3 bricks screw side firebricks installation 1) put 3 bricks «a» and 1 angled brick «c» beside the right air corridor. ». 2) start to screw the brick screw just enough to install the...
Page 11
11 2) put four (4) bricks « e » over the two front pipes. It must be placed like the illustration. Be sure to eliminate any gap space between back bricks previously placed. 3) put the rockwool over the bricks and assume then the smoke exit way is not obstructed. 4) put two half metal disk over the r...
Page 12
12 general stove installation steps. 1) read the entire owner and installation manual before install and use your stove. 2) chose a spot where to install your cook stove. Read section about floor protection dimension and about localisation of stove over the floor protection plate, and for combustibl...
Page 13
13 chimney connector installation. The chimney connector is a set of single wall or double wall flue pipes and elbow installed between the stove collar and the chimney collar. The single wall chimney connector is sold into any hardware store and are not homologated and certified. Some rules must be ...
Page 14
14 chimney installation, general steps use only approved chimneys. The same size as the output collar. 6 inches in this case. The chimneys used must be tested according to can/ulc s629 m87 in canada and to ul 103 (type ht) in usa. The cook stove can be install with a masonry chimney according to ulc...
Page 15
15 inside masonry chimney, vertical installation the wood appliance must be installed in accordance with the applicable local laws or the can/csa-b365, nfpa211 (usa) norms. Follow the chimney manufacturer’s instructions to install the chimney. The chimney masonry must have inside a certified metalli...
Page 16
16 cathedral vertical installation the wood appliance must be installed in accordance with the applicable local laws or the can/csa-b365, nfpa211 (usa) norms. Follow the chimney manufacturer’s instructions to install the chimney. Always pass chimney between joists. If a joist need to be cut, referri...
Page 17
17 vertical installation the wood appliance must be installed in accordance with the applicable local laws or the can/csa-b365, nfpa211 (usa) norms. Follow the chimney manufacturer’s instructions to install the chimney. Always pass chimney between joists. If a joist need to be cut, referring to the ...
Page 18: Source.
18 6. External combustion air source. In conventional designed house, natural ventilation is enough to operate the wood stove. In some new energy saving house, natural ventilation is not enough to good operation of your stove. To avoid reverse circulation of smoke caused by negative pressure when tu...
Page 19
19 stainless steel deflector replacement. Add-on stainless-steel plate are used into combustion chamber to protect the steel from wear corrosion cause by extreme temperature and extreme conditions into combustion chamber. When it’s too wear they have to be replaced. Front deflector add-on replacemen...
Page 20
20 2) align and insert the groove into the other side. 3) push completely the grooved end and insert the cotter pin into the last hole at the other side. . 4) split the cutter pin to lock it 5) install the next tube to remove tubes, do steps in reverse order tube support installation. Put the suppor...
Page 21: 7. Operating Instructions
21 7. Operating instructions • operate only when door is closed: keeping the door open can over fire and do permanent damage to the stove or a chimney fire. • it’s recommended to install a co, co2 and smoke detector into the same room than the stove. • never slap the door. • never burn inflammable l...
Page 22: 8. Maintenance.
22 8) adjust the air admission handle to needed setting. Never leave the stove unattended when the door is sightly open. Always close the door after adding a load. Caution: never use gazoline, gazoline type lantern fuel, kerosen, charcoal lighter fluid, or similar liquids to start or “freshen up “a ...
Page 23
23 chimney sweeping. Chimney sweeping need a special tool like some fiberglass rod an adapted diameter brush and some rope sweeping chimney also requires to climb on the roof to remove the chimney cap and sometime a too high chimney section too. We recommend to call a professional chimney sweeper ce...
Page 24
24 6) check the tightening tighten it too much can make a pressure point and can break the glass when it became hot if you cannot replace glass in place you may have to remove the door to make it. Look in this manual to know how. Fiberglass rope replacement. Use a ½ inches (12.7mm) braided fiberglas...
Page 25: 9. Appendix 1
25 9. Appendix 1 door assembly square door.
Page 26
26 arc door.
Page 27: 10.
27 10. Appendix 2 fans electric wiring diagram. Therm-o-disk box parts description..
Page 28: 11.
28 11. Appendix 3 parts that can be replaced • bricks • stove ceramic glass arc • stove ceramic glass rectangular • spring handle • stove door with handle • fans • flat fiber glass rope (around glass) • round fiberglass rope • ash plug • slotted brick washer to ordered parts call your stove seller r...
Page 29: 12.
29 12. J. A. Roby limited life warranty – wood burning stoves & fireplaces j. A. Roby’s warranty only applies to original buyer and is non-transferable. This warranty covers brand new products only, which have not been altered, modified nor repaired since shipment from factory. The products covered ...