J. A. Roby ultimate 2015 Instruction Manual - page 24
24
6) Check the tightening Tighten it too much can make a
pressure point and can break the glass when it
became hot
If you cannot replace glass in place you may have to remove
the door to make it. Look in this manual to know how.
Fiberglass rope replacement.
Use a ½ inches (12.7mm) braided fiberglass rope.
It is possible to replace the braided fiberglass rope with the
door on the stove, but if you want you can remove door.
Fiberglass rope preparation.
1) Take the end of the fiberglass rope and push fiber
inside to make a clean end.
2) Add little touch of high temperature latex inside the
end of the fiber glass rope.
3) Remove old fiberglass rope and clean the groove
4) Starting at the lower corner near the hinge put the
fiberglass rope into the grove without giving any
tension and cut it ½ inches over the require length
5) Take the fresh cut end of the fiberglass rope and push
the fiber inside to make a clean end.
6) Add high temperature latex inside the end of
fiberglass rope.
Fiberglass rope installation.
1) Put a high temperature latex inside the clean groove
to glue the fiberglass rope.
2) Starting at the lower corner near the hinge put
fiberglass rope into the groove without giving any
tension
3) Align the two fiberglass rope ends and put some high
temperature latex between.
4) Install the door if you uninstall it
What to do in case of Chimney Fire.
Contact your local authority to know what to do in case of
Chimney fire. And be sure to know procedure in case of
chimney fire.
1. Close all door and put the handle to secondary position.
2. Close damper
3. Spay water on combustible material around stove.
4. Call Fire department and trigger alarm.
5. Never touch the chimney while is burning.
6. Do an inspection to chimney and repair it when needed.
.
.