J&M Corporation INTEGRATR V MI-2034 Installation And Operation Instructions - page 4
• Adjust the volume of the FRS radio to be received at a
comfortable level. Use the FRS radio volume control to do this
(you need to receive a real transmission to do this) before the
ride begins.
• Incoming FRS radio transmissions will activate the intercom
system, mute the music (Level 1), and will be heard by rider and
passenger. Rider and passenger can discuss what is being heard
from the FRS radio without that conversation be transmitted.
• To transmit, rider must press and hold the PTT button.
• The 3.5 second delay of the intercom system aids two-way
radio conversations, since most users don’t say “over” when their
statements are finished. The 3.5 second delay also provides time
to bridge the natural pause that occurs while listeners determine
the incoming speech has ended, before they respond.
Note:
If you receive a cell phone call while riding with the
FRS radio in use, the cell phone will mute all Level 1 & 3
communications. However, if (out of habit) you press the PTT
button while talking on the phone that portion of your phone
conversation could be transmitted over the FRS radio.
Note:
The range afforded with the FRS radio will vary depending
upon terrain, weather conditions, outside sources of interference,
etc.
Radar Detector
• Mount your radar detector to the motorcycle and connect it to
the IntegratrV with one of the optional connection cables.
• Radar detectors will momentarily mute all other audio,
momentarily muting all other forms of communication only in the
right speaker of the helmet headset. Therefore, the left speaker
will still be playing whatever audio is being used, but the right
speaker will play the warning tone.
Use of radar detectors may not be approved in all States. Please
consult and observe all local regulations.
Noise and Interference
Motorcycle audio systems by their very nature are noisy. While
we do not guarantee this system to be completely free from
electrical noises and interference, we have taken many steps
to achieve that goal: the power supply system is well filtered,
the unit is shielded in its metal container, and the cables
associated with the unit are shielded.
Most modern day motorcycles have resitor-type spark plugs
installed by the factory. It may be necessary to insure that
resistor-type spark plugs are installed on your motorcycle.
Power requirements: 11-16 volts DC negative ground
Minimum speaker impedance: 32Ω
Typical current draw: 1.5 amps
Thank you for the confidence you have shown in J&M Corporation by
purchasing one of our innovative products.
If you have any question or comments about this product, you may
contact us at USA 1-520-624-7000 Monday thru Friday, 8:00AM
thru 5:00PM Mountain Standard Time.
1415 S. Cherry Avenue
Tucson, AZ 85713 U.S.A.
Tel: (800) 358-0881
Website: http://www.jmcorp.com
E-mail: audio@jmcorp.com