J&M Corporation STAGE-4 ROKKER XXR XXRK-630SP4-15RU-CVO Installation Instructions Manual - page 2
Product Overview
This is the new J&M STAGE-4 ROKKER® XXR Custom 630w 4-speak-
er/amplifier installation kit for your 2015-2017 Harley Roadglide Ultra
CVO (ONLY) with the Harley 6.5GT Premium CVO radio.
At the very heart of this system is our in-fairing mounted 4 channel
ROKKER XXRP amplifier rated @ 157.5w RMS per channel X 4 to
provide up to 630w total RMS power!
The amplifier will be custom tuned for use in conjunction with your
specially FLASHED Harley Infotainment radio (Diag4bike digital
technician “J&M Audio Custom” menu option), to provide THE BEST
on-highway volume, clarity and overall performance available, from
your music source selections of FM stereo, XM sat radio, Smartphone
or USB thumb drive.
(Harley Infotainment CVO radio to be shipped to the J&M factory in
Tucson for FLASHING prior to ordering STAGE 4 custom CVO kit &
there is a separate $75 fee for the “J&M Audio Custom” Harley radio
FLASH).
Included are J&Ms fully weatherproof 6.71” ROKKER XXR fairing &
rear-pod speakers featuring a high-tech woven-fiber woofer cone & a
massive high-density high-flux strength Neodymium magnet structure
with large center & perimeter positioned voice coil cooling vents, to
provide for maximum heat dissipation when operating at high volume
levels for extended periods.
The custom designed speaker grills with mounted high-output dome
tweeters are also weather-proof and shock-proof for maximum long-
term durability.
This STAGE-4 ROKKER XXR custom installation KIT has been engi-
neered to be 100% plug-and-play for your convenience during the
installation and to maintain the complete integrity of your Harley
RoadGlide Ultra CVO’s internal wiring harness.
The new J&M music-source test USB thumb-drive is also included for
your performance comparison testing.
Fairing Speaker Installation
1. Remove the stock fairing grills by gently prying up the inner edge
of each grill & pull outward. (Fig. A)
2. Remove the 4 torx attachment screws from each stock
speaker, unplug the wires from the rear and remove both speak-
ers from the fairing pods. (Fig. B)
3. Install the new 6.71” ROKKER XXR speakers using the original-
speaker attachment screws; Ensure that the speaker is placed
into the pod with the tweeter-wire plug exiting to the upper, outer-
corner. (Fig. B)
4. Install new ROKKER grill by first plugging in the backside tweeter
wire to the speaker, then place into position and pressdown until
locked at all four corners. (Fig. C)
Fig. B
Fig. A
Fig. C
Remove