J&M ROKKER XXRP 630W Installation And Operation Instructions - page 3
Speaker
Enclosure
Speaker
Enclosure
Remove
2-pin
12v plug
Connection to Amp
Fig. B
Fig. C
power/ground cable (Red and Black wires) facing towards the
left side of the bike.
6. Connect the amplifier main wiring harness to the amp
before securing to the mounting bracket. Center the amp into
position, place top bracket with J&M Logo facing up, align the
screw holes and insert three of the four supplied screws and
tighten securely. (Figure C)
7. Connect the main power cable and tuck wire down on the
side of the amplifier so as not to interfere with the radio as it is
reinstalled. Connect the RCA input harness to the amplifier.
8. Make Amplifier/Speaker connections as per diagram.
(Figure D)
9. Re-install the factory radio.
10. Test the system for proper operation before reassembling
the fairing, realizing that full sound quality and fidelity will not
be heard until the outer fairing shell is completely reinstalled.
Important Programing Note:
The amplifier gain & frequency
response adjustments have been pre-programed at our factory
for this specific Harley Davidson audio system application, using
speakers with an impedance of 2-ohms, to provide maximum
performance at highway speeds. Should speaker impedance
change, an alternate software programing package will need to
be downloaded & flashed to the digital signal processor inside
the amplifier. This programming service is available direct
from ‘J&M Corporation in Tucson AZ USA. Send email direct to
ROKKER_DSP_Pro@jmcorp.com