JabloCom BTP -06L User Manual - 7.5 Disposal Information
BTP-06.L.ENG.MAN.User_manual.03
- 18 -
Blasting caps and areas
The device isn’t recommended to be used in a blasting area or in areas posted for turning off “two-way radios” or “electronic devi-
ces” to avoid interfering with blasting operations. Observe restrictions, and follow all regulations and rules.
Do not attempt to disassemble your device or its accessories — only qualified personal may install or repair device equipment. If
your device or its accessory has been submerged in water, punctured, or subjected to a severe fall, do not use it until you have taken
it to be checked at an authorized service centre.
Always treat your device and its accessories with care and keep it in a clean, dust-free place.
Do not paint your device or its accessories.
Do not expose your device or its accessories to open flames or lit tobacco products.
Do not expose your device or its accessories to liquid, moisture or high humidity.
Do not drop, throw or try to bend your device or its accessories.
Do not use harsh chemicals, cleaning solvents, or aerosols to clean the device or its accessories.
Do not expose your device or its accessories to extreme temperatures below -10 or above +55 degrees Celsius.
Remember to make backup copies of all important data.
When connecting to any other device, read its user guide for detailed safety instructions.
7.5 Disposal Information
Before disposing of the device, render it unusable.
When disposing of material, it is necessary to adhere to the pertinent national regulations for the disposal of waste.
All used packaging materials are ecological and may be
reused or recycled. Please contribute actively to saving
the environment and pay special attention to the correct
disposal and reuse of packaging materials.
© Copyright 2011 by JABLOCOM. All rights reserved