JabloCom BTP -06L User Manual - 3.3 Call History
XE_BTP-06.ENG.MAN.manual_L.02.A
- 11 -
Please note that the BTP-06L only READS data from your mobile phone’s memory. To prevent any
possible unwanted changes in your mobile phone, the BTP-06L never writes anything into your mobile
phone‘s memory.
To avoid excessive discharging of your mobile phone batt ery, automati c synchronizati on will not be run more than
once per hour.
If you wish to apply the most recent changes in your mobile phone contacts to the BTP-06L, go to the contact list
and select
to acti vate synchronizati on manually.
3.3 Call history
The BTP-06L stores the call history. There can be up to 100 calls stored in the memory. If the memory is full, the
oldest record of the same type is automati cally erased.
The BTP-06L also synchronizes the call history with your mobile phone (if supported by your mobile phone).
Press
to view the complete call history.
If you prefer to see just
Missed
( ),
Incoming
(
) or
Outgoing
(
) calls, then select the
Filter
.
Additi onal functi ons are available under the
Options
menu for each call record:
Details
- extended informati on about the call number, date, ti me, count
Call
- dial the number of the selected call record
Send SMS
- send a text message to the selected number
Delete
- delete this call record from the call history log
Store number
- save a number in your phonebook
Delete all
- delete all call records from the call history log
3.4 Text messages
Please note that some mobile phones may not support this functi on – please check the table of functi ons
supported by your mobile phone – chapter 3.
Ꮀ Write and send a text message
Press the
key, located on the upper left -hand side of your phone’s keybo-
ard to start writi ng a new message. Write the text and press the
Send
selecti on
key. Enter the recipient’s phone number or select the name from the contacts
(use
). Confi rm the recipient’s number and then send message with
OK
.
-
Hold for 2 seconds to switch between
Abc
,
abc
or
ABC
character opti ons.
- Press to delete previous character.
-
Press briefl y to display
symbols above QWERTY keys
.
- Press for
2 seconds
to display
extended symbol chart
.
Press
Insert
to place the symbol into the text.
Ꮀ Opening an incoming message
Receipt of a new text message is indicated by an acousti c signal, by the
fl ashing of the red indicator light and by the envelope symbol
on the LCD.
Press
to read the received text message and scroll through
the message by using
.
Additi onal functi ons are available under the
Options
menu:
Delete
- deletes the current text message
Reply
- sends a reply to the message sender
Forward
- forwards the message to another recipient
Call
- calls back the message sender
Details
- shows detailed informati on about message sender and ti me
New...
- starts a new text message
Store number
- saves the message sender’s number in your phone book
Delete all
- deletes all messages in the current folder
To read previous incoming messages or to send messages, open the
Messages
menu by pressing
and select
Inbox
or
Sent
.