JabloCom GDP – 02 User Manual - page 4
JABLOCOM
User’s Guide
HB53019_ENG.doc
2 www.jablocom.com
P
LUGGING IN THE
P
HONE FOR THE
F
IRST
T
IME
1. Connect one end of the phone’s AC adapter to the phone’s power socket and the other end to an AC wall outlet.
2. Once you plug in the AC Adapter for the first time the phone should automatically power up.
3. Locate the battery switch at the rear of the phone and flick it to the ON position to automatically begin charging the internal
backup battery.
4. If the phone requests a PIN code, enter it and press
3
.
Warning: Do not switch on the phone where wireless phone use is prohibited or where it may cause interference
or danger.
S
WITCHING
T
HE
P
HONE
ON
AND
OFF
1. To switch the phone ON, press down on the key for a few seconds until you see the following message on the display: “The
phone is starting…” If you are operating the phone on battery power, the ON-OFF switch located at the rear of the phone
must be set to the ON position in order to turn on the phone.
2. To switch the phone OFF, press and hold the
key. Hold the button down until you see “The phone is switching off…”
message on the display.
Operating the Phone on Battery Power
Under normal use, the phone should be powered from the AC adapter. If the power is disconnected, the phone will automatically
switch to backup battery mode (the battery status bar will appear on the right-hand side of the display). The phone is capable of
working in standby mode using battery power for approximately 24 hours. However, a phone call of approximately 60 minutes will
completely discharge a fully charged battery (a weak network signal as well as temperature and other operational conditions can
adversely affect the duration of a call made using battery power). If the phone is powered from the battery, reduce your phone calls
to a minimum and if you do not need the phone, flick the ON-OFF battery switch located at the rear of the phone to the OFF
position to conserve the battery.
If the battery is empty, the phone will automatically switch off. In this case the phone can be switched ON only by connecting the AC
adapter (to fully charge the battery takes approximately 24 hours). The phone can be used while the battery is charging.
Note: Your phone is equipped with an internal rechargeable battery. The battery can be charged and discharged
hundreds of times but it will eventually wear out. It is recommended to have your dealer replace your battery once it
wears out.