JabloCom JabloPhone GDP-04i User Manual - Remote Control
xXC_GDP-04i.ENG.MAN.Manual.10.C
- 13 -
EN
U
se
r‘
s
G
u
id
e
Problem / Error message
Solution
Sending failed
Your text message was not sent to the network correctly. Check the phone number and try again. If the error
repeats, contact your service provider.
Analogue line error - deactivated
Possible problem on the attached analogue phone. Unplug the GDP-04i power adaptor, check your analog
phone and its cable and reconnect power adaptor to the GDP-04i.
Error
Wrong input or action was performed, for example an incorrect service code or an incorrect SIM toolkit
command. Confirm you are using correct code.
Incorrect entry
An incorrect PIN was entered. Enter a correct one.
System error
Internal error of the phone. Switch the phone off, disconnect the internal battery for about 10 seconds and
then switch the phone on again. If the error repeats, return the phone for service.
GDP-04i RF – wireless control guide
Social security alarm – PANIC button
GDP-04i RF sends a text message and/or dials a call to defined phone numbers as a result of pressing a panic button
enrolled it.
All settings are done in the
Menu -> Settings -> PANIC button
menu.
Choose
Remote controls
and
to enroll a new panic button. Press the button and confirm its
enrollment by pressing
Save
. Enter the name under which it will be displayed and press
OK
. If you want to edit or
delete a previously enrolled remote control, select it in the list and choose
Options -> Edit
or
Delete
.
Choose
Emergency numbers
and
to set a new emergency number. If you want to delete a
previously entered one, select it in the list and press
Delete
.
Choose
Emergency messages -> Edit SMS
to set an emergency message text. If you choose
Clear SMS
option or if you delete the message text completely, no SMS will be sent to emergency numbers.
Up to 10 buttons can be enrolled to the phone at the time. You can enroll Jablotron OASiS wireless acces-
sories - RC-87 panic button, RC-88 wall button or RC-89 doorbell button – to GDP-04i RF as panic buttons.
Remote control
A wireless relay can be operated via SMS sent to GDP-04i RF. All settings are done in the
Menu -> Settings ->
Wireless relay
menu.
To enroll a new wireless relay, switch it into the enrollment mode and choose
Enroll new relay
on the phone.
The phone sends the enrollment signal immediately.
Enter the messages for operating relays 1 and 2 in the
Set SMS commands
menu. The respective command is
sent to the relay immediately after an SMS with the identical text is received.
There is no restriction for commanding phone number so that you should include some security sequence into your
commands and keep them secret to avoid misuse.
You can enroll Jablotron OASiS wireless relays AC-82 or UC-82 to GDP-04i RF. For more information
about the accessories, including user’s guides, please visit
www.jablotron.com
.