Jabra BT3010 - Headset - In-ear ear-bud User Manual - page 7
6
EN
g
Li
Sh
JABrA BT3010 BlUeTOOTh heADSeT
2. Set your Bluetooth phone to ‘discover’ the Jabra BT3010
• Follow your phone’s instruction guide. First make sure that
Bluetooth is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going to a
‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and select-
ing the option to ‘discover’ or ‘add’ a Bluetooth device.*
3. Your phone will find the Jabra BT3010
• your phone will find the headset under name “Bluetooth head-
set”. your phone then asks if you want to pair with the headset.
Accept by pressing ‘yes’ or ‘Ok’ on the phone and confirm with
the passkey or pIN = 0000 (zeros). your phone will confirm
when pairing is complete.
Fig. 4
Connectivity
MobilSurf
Bluetooth
Infrared port
WAP options
Synchronization
Networks
Select
Info
Handsfree
Ok
Bluetooth headset
Added. The
handsfree is now
ready for use
Devices found
Select
Bluetooth headset
Ok
Passkey:
JABRA BT3010
In case of unsuccessful pairing, put the Jabra BT3010 into
pairing
mode manually. Make sure the headset is off. press and hold the
answer/end button for approximately 5 seconds until the leD has
a constant light.The leD will flash before the light is constant –
keep holding down the button until light is constant
.
1
2
* phone dependent