JAC wiJAC-P Series Operating Manual - Introduction
wiJAC-Pxx Wireless Stand Alone Intercom System
Operating Manual
Page 1
1
Introduction
This manual contains the operating instructions for the
wiJAC
-Pxx Wireless
Stand Alone Intercom System. The diagram below describes the naming method
for the different systems.
wiJAC-P x x
The
wiJAC-Px1 – N America
consists of one JA65-001 Headset Adapter Master,
and up to four JA64-001 Headset Adapter Slaves.
The
wiJAC-Px2 – Europe
consists of one JA65-002 Headset Adapter Master,
and up to four JA64-002 Headset Adapter Slaves.
The
wiJAC-Px3 – Japan
consists of one JA65-003 Headset Adapter Master, and
up to four JA64-003 Headset Adapter Slaves.
Only paired units will operate together (see
section
4
)
System operating information is in
section
5
.
2
.
WARNING
:
JAC recommends that no battery operated device
should be relied upon as the sole method of communication in
cases where there is potential risk to life or limb.
1.1
Unpacking
Unpack the
wiJAC
™ box carefully, and ensure that it contains the following:
•
one Wireless
Headset Adapter Master
, JAC P/N JA65-00x
•
one
to four Wireless
Headset Adapter Slaves
, JAC P/N JA64-00x
•
one set of AAA rechargeable batteries for each unit
•
one USB to Micro USB cable, JAC P/N CAB-USB-0003 for each unit.
•
one
wiJAC
™ Quick Start
User
Guide, JAC P/N DOC-GUID-WIPXXU
•
one
wiJAC
™ Quick Start
Pairing
Guide, JAC P/N DOC-GUID-WIPXXP
1.2
Verify Operating Region
The
wiJAC
-Pxx Wireless Intercom System operates using radio frequencies that
are authorized by government regulatory agencies. Ensure the region in which
you are operating the units matches the region marked on a label on the back of
each unit.
Number of Headsets
in the System (2 – 5)
Operating Region:
1 = N America
2 = Europe
3 = Japan
System Type:
P = Person to Person