JAC wiJAC-P Series Operating Manual - page 9
wiJAC-Pxx Wireless Stand Alone Intercom System
Operating Manual
Page 5
4
Pairing and Purging Process
The
wiJAC
-Pxx Wireless Intercom Systems consist of one JA65 Headset
Adapter Master (green ON/OFF button), and up to four factory-paired JA64
Headset Adapter Slaves. Any additional Headset Adapter Slaves must be paired
with the Headset Adapter Master before the expanded system can function
correctly. Once pairing is complete, the three character Pairing Registration
Number from the back of the JA65 should be written on the label on the back of
each paired JA64 using a permanent marker. Ensure that the same number is
marked on each unit.
To locate the pair switch, the battery cover must be removed from the unit.
4.1
Pairing
The JA64/JA65 pairing process is described in the following steps:
1. Turn off the JA65 and any other JA64 previously paired with the JA65.
2. Turn on the JA65.
The JA65 enters the standby mode (Power Annunciator blinks in sets of
two or three flashes). If the Power Annunciator stays on continuously,
there is a JA64 still powered on and connected to the JA65. Please turn
off the JA64.
3. On the JA65, press and hold the Pair Switch (4 seconds) until the
Power and Low Battery Annunciators start flashing rapidly (10 flashes
/second). Release the Pair switch.
The JA65 enters the pairing mode (Power Annunciator is flashing at a
medium rate (5 flashes /second) and can now be paired with a JA64.
4. Turn on a JA64 to be paired with the JA65.
The JA64 enters the standby mode (Power Annunciator blinks in sets of
two or three flashes).
5. On the JA64, press and hold the Pair Switch (4 seconds) until the
Power and Low Battery Annunciators starts flashing rapidly (10 flashes
/second). Release the Pair switch.
The JA64 enters the pairing mode (Power Annunciator is now flashing at a
medium rate (5 flashes /second) and will complete the pairing process
automatically with the JA65.
The JA64 and JA65 indicate they have completed the pairing process when the
Power Annunciator is on continuously.
When the battery cover is removed,
the pair symbol and switch access
hole can be seen on the edge of the
compartment. Insert a straightened
paperclip into the hole to press the
button.
Switch Access
Pair Symbol