Jackson grills premier series owner’s manual this manual is for use with jpg700, jpg700bi-2 and jpg850bi-2 series grills warning: please read and understand the contents of this manual fully before operating. Failure to do so may result in fire or explosion. Homeowners should retain these instructio...
2 table of contents: safety 3 lp gas cylinder replacement 4-5 opd equipped cylinder 6 hose and regulator 6 leak testing 7 installation 8 clearances 9 assembly 10-13 getting to know your grill 14 lighting instructions 15 gas conversion 16-18 maintenance 19 grilling tips and techniques 20 trouble shoo...
3 safety: your new jackson grill barbeque is a safe, convenient appliance when used and maintained properly. As with all gas-fired appliances, certain safety precautions must be observed. Failure to follow these precautions may result in damage or injury. If you have any questions or concerns regard...
4 lp gas cylinder placement: cylinders must be installed according to assembly instructions. Install the gas cylinder into the tank hole inside of the jackson pedestal. Lp gas cylinder: qcc-1 quick closing coupling your grill is designed to be used with an lp gas cylinder equipped with the new qcc-1...
5 handling: 1. Government regulations prohibit shipping full lp gas cylinders. You must take your new cylinder to an lp gas dealer for filling. 2. A filled lp gas cylinder is under very high pressure. Always handle with care and transport in the upright position. Protect the valve from accidental da...
6 opd equipped cylinder: effective january 1, 1998, the standard for outdoor gas appliances, ansi z21.58/can cga-1.6, requires that appliances are to be used with cylinders equipped with an overfill prevention device (opd). The opd is designed to reduce the potential for the overfilling of propane c...
7 4. Leak test the connection. See “leak test”. 5. Refer to lighting instructions. To avoid activating the flow limiting device when lighting, open the cylinder valve slowly with the appliance valves off. If the flow limiting device is accidentally activated, turn off cylinder valve and appliance va...
8 installation: in canada, this appliance must be installed in accordance with the local code and relevant cga standards: can/cga-b149.1 lp gas/propane installation code and latest codes where applicable. In the usa, this appliance must be installed in accordance with the local code and relevant nat...
9 installing 700bi-2 / 850bi-2 into a non combustible island. All dimensions are in inches: 700bi-2 850bi-2 a 32.5 39.5 b 9 ” 9 ” c 17” 17” d 10 ” 10 ” e 3” 3” f 17.25” 17.25” g 24.25” 24.25” h 24” min. 24” min. I 18 ” 18 ” j 5.5” min 5.5” min installing 700bi-2 / 850bi-2 into a combustible island. ...
10 assembly: please ensure the proper tools are used for ease of installation. Some assembly will be required if this unit is installed in a pedestal. Please remove all components from the packaging and inspect all components to ensure there is no damage to any components in the packaging. If damage...
11 secure the condiment bins to the display panel using the screws from the securing plates. After the side shelves have been installed, ensure the grill head is pushed back in the pedestal as far as possible. With the screws removed from the securing straps, place a screw through the side of the co...
12 rotisserie rod bushing placed on the cut out provided on the inner hood rotisserie kit completed installation upper flavor shield, cooking grid installation remove the upper flavor shields from the packaging. Please ensure that all protective plastic has been removed from these parts. These upper...
13 main gas line connections for propane gas and natural gas the main fuel supply gas line is connected to a manifold tee securely mounted inside the pedestal located on the left hand side of the pedestal. Remove the propane hose and regulator assembly from the packaging. Please ensure that there is...
14 getting to know your grill 1 outer hood handle 11 pull out grease tray 2 hood thermometer 12 main control knobs / display panel 3 outer hood 13 electronic ignition 4 cooking grids x 2 14 side burner side shelf 5 side shelf 15 warming rack 6 condiment bins x 2 16 infrared rear burner 7 pedestal 17...
15 main burner lighting before lighting: carefully inspect the gas supply hose before turning the gas “on”. If there is evidence of cuts, wear, or abrasion, it must be replaced before use, the replacement hose assembly shall be that specified by the manufacturer. Very important: always inspect the h...
16 main burner orifice main burner use when searing foods, preheating is recommended by operating all main burners in the hi position with the lid closed for approximately 6-10 minutes. 9-10 minutes for colder climates, 6-8 for milder/warmer climates. Cooking with the lid closed will ensure a more e...
17 rear burner. 1 using a # 2 phillips screwdriver undo the 4 screws that hold the back cover plate to the inner hood. 2 once the cover has been removed use a 7 mm wrench to remove the rear burner orifice from the rear burner. 3 install the new rear burner orifice using an approved thread sealant. 4...
18 side burner 1 open the side burner lid and remove the grate over the burner head. 2 undo the 2 phillips head screws that hold the flame thrower (burner ignition) and very carefully move away from the burner head. 3 undo the 3 screws that hold the burner head onto the side shelf base. 4 remove the...
19 gas line remove the 3/8” flare fitting that attaches the propane hose from the manifold block inside of the pedestal and replace with an approved 10’ natural gas hose neoprene hose. Part # nghose remember to leak check all fittings and orifices after all of the conversion is completed, leak check...
20 food safety tips and techniques we want to enjoy healthy and safe grill cooking, so here are some tips for basic barbecue hygiene: bacteria are living organisms that grow and multiply rapidly in warm moist foods. Marinate meat in the refrigerator and take it out one half hour before grilling, if ...
21 trouble shooting problem possible causes solution low heat or low flame when valve turned to high. For propane – improper lighting procedure. Ensure lighting procedure is followed carefully. All gas grill valves must be in the off position when the tank valve is turned on. Turn tank on for all pr...
22 parts list part number part description quantity 1 07-400 outer hood 1 2 04-3403 warming rack bracket 2 3 07-402 hood handle 1 4 07-4505 thermometer 1 5 07-403 inner hood 1 6 07-404 rear burner mount 1 7 07-4508 inner hood back cover 1 8 07-405 warming rack 1 10 07-4506 upper flavor shields 4/5 1...
23 exploded view 1 2 3 4 5 6 7 8 12 2 14 18 50 26 28.
24 jackson grills limited lifetime warranty jackson grills inc. Warrants the following materials and workmanship to be free of defects for as long as you own the grill. This covers the following components: main stainless steel outer hood, stainless steel cooking grills, stainless steel outer pedest...
25 a special message to our customers thank you for choosing the jackson grill for your new gas grill. This appliance is designed with quality components and we are confident that it will provide you with years of excellent operation. Please take the time to read the whole manual and familiarize you...