Jackson TEMPSTAR Installation & Operation Manual - page 66

Tempstar LT/NB/S/SDS Technical Manual 7610-011-86-35 

Issued: 12-07-2007  Revised: N/A

SECTION 5: PARTS SECTION

58

DRAIN QUENCH ASSEMBLY

From the existing drain, attach the two additional Tees using the 1-1/2” NPT Close Nipples. Tighten the Reducers into the Tees

as shown above. Attach the Modified Compression Fitting  into the 1-1/2” to 1/4” Reducer. Position the bulb of the thermostat

so that it rests approximately 1/4” from the bottom of the Tee. Tighten the Modified Compression Fitting as required. Attach to

the incoming cold water line. Use pipe dope or thread tape as required to prevent any leaks. 

Thermostat

05930-003-13-65

Solenoid Valve

04810-100-09-18

To Cold Water Supply

Nipple, Close, 1/2” NPT

(Not Shown)

04730-207-15-00

Valve, Check, 1/2”

(Not Shown)

04820-002-55-77

Lid, Drain Quench

05700-002-67-16

Box, Drain Quench

05700-002-69-96

Reducer, 1-1/2” to 1/2”

04730-002-55-75

Tee, 1-1/2” x 1-1/2” x 1-1/2”

04730-011-69-93

Modified Compression

Fitting

05700-001-16-52

Reducer, 1-1/2” x 1/4”

04730-002-55-76

To Dishmachine Drain

Nipple, 1-1/2” NPT

04730-207-40-00

Elbow, 1-1/2” 90

° Street

04730-206-32-00

Drain Quench

Assembly

06401-002-59-52