- DL manuals
- Jacuzzi
- Plumbing Product
- J-CARRE
- Owner's Manual
Jacuzzi J-CARRE Owner's Manual
Summary of J-CARRE
Page 1
Owner’s manual installation & operating instructions j-carre shower system ´ tm whirlpool bath r.
Page 2: Important Safety Information
Important safety information read all installation instructions jacuzzi whirlpool bath does not recommend prolonged periods of use of the steamer. Prolonged use of the steam system can raise the internal human body temperature excessively and impair the body's ability to regulate its internal temper...
Page 3: J-Carre´
50.00 50.00 j-carre´ 2.
Page 4: Electrical Requirements
Installation & operating instuctions electrical requirements your j-carré, as it comes from the factory, requires a gfci 240 vac15 amp 3-wire circuit (2 conductor with ground) for single (1) phase electrical service and must be in a separate circuit having no other appliance connected in that circui...
Page 5
Read all instructions before beginning installation. Room construction: important the room where the shower unit is to be located must be constructed of materials that can withstand excessive amounts of moisture and condensation. Large amounts of steam can be released into the room when the shower d...
Page 6: Rough-In
Installation & operating instructions washing machine outlet box connect #8 gauge (10mm 2) minimum solid copper bond wi re to the hous e ele ctri ca l panel or approved local ground. An approved ground may be an 8 foot long ground rod (3 meter long earth rod), a plate electrode, or other acceptable ...
Page 7
1. Adjust the levelling screws in the base frame and lock them in position. 2. Connect bonding wire from line cord junction box to proper ground. (see bonding, page 8.) 3. Connect hot and cold water supply lines. 4. Plug in electric line cord. 5. Move j-carré into final position. Make final leveling...
Page 8: Equipment Access
Installation & operating instructions equipment access line cord junction box solenoid valves hot and cold water supply lines leveler and drain access drain remove hardware and open service panel for access steam tank stub-out steam tank drain line 7.
Page 9: Bonding
Installation & operating instructions connect #8 gauge (10mm 2 ) minimum solid copper bond wire to the house electrical panel or approved local ground. An approved ground may be an 8 foot long ground rod (3 meter long earth rod), a plate electrode, or other acceptable bond. Check your local building...
Page 10: Cover
Installation & operating instructions cover lay a bead of sealant on top of frame as shown in illustration. Lay cover in place making sure that the holes in the cover line up with the holes in the frame and then install the two locating pins provided. Anchoring the j-carré to the wall anchor unit to...
Page 11: Sliding Door Adjustment
Installation & operating instructions sliding door adjustment the sliding doors have been factory adjusted for shipping purposes. It will probably be necessary to readjust the doors prior to use. With the sliding doors in the closed position, check to make sure that the magnetic strips on each door ...
Page 12: Shower
System control is provided by the electronic display located inside the shower cabin (see fig. 2) the display is used to start up the four functions of the unit: the shower, the cascade, the hydromassage and the steam bath. The display is composed of four distinct areas with clear symbols which allo...
Page 13: Starting The Steam Bath
Starting the steam bath the beneficial effects of a steam bath have been recognized since ancient times. The steam bath has long since become part of every culture. H. Press the steam bath button 1 on the display (figure 2). At this point, the time display will indicate 00 and the green light above ...
Page 14
During the steam bath treatment, the time can always be varied by pressing the (+) and (-) buttons without interrupting the function. Also for your convenience, a buzzer will sound when the steam timer reaches zero (00). There is a 10 second delay before the steam bath function is cancelled. During ...
Page 15
Electrical diagram sol. Valve for drainage cable to electric pump 3 2 1 4 power supply cable (220/240v) cable to level probe (12v) cable to electric heating (220/240v) electric control box sol. Valve filling sol. Valve waterfall sol. Valve shower sol. Valve turbomassage (12v) (12v) computer cable (1...
Page 16
©1994 jacuzzi whirlpool bath e242000 4/94 jacuzzi whirlpool bath national headquarters p.O. Drawer j, walnut creek, ca 94596 (510) 938-7070 customer service: call (800) 288-4002 product specifications are subject to change without notice. Use installation instructions supplied with product. Printed ...