Jacuzzi J-CARRE Owner's Manual - Shower
System control is provided by the electronic display located inside the shower cabin (see Fig. 2)
The display is used to start up the four functions of the unit: the shower, the cascade, the hydromassage and the steam bath.
The display is composed of four distinct areas with clear symbols which allow you to easily identify the four main functions.
Operating Instuctions for J-Carré
11
To start any functions:
A. Turn the diverter knob (X) to the outlet under seat position
and open the waterflow by pulling the mixer lever (Y). Then
adjust water temperature by turning the mixer lever while
checking the water temperature with your foot.
B. Turn the diverter knob (X) to the electronic functions
positions to close the water outlet under seat.
FIGURE 1.
FIGURE 2.
Shower
To start the shower, carry out the preliminary operations A and B previously described and then proceed as follows:
C. Press the shower button 5 on the display (Fig. 2). To stop the shower, press the same button again. The green light above
5 lights when the functions starts and turns off when it stops. In case of power failure after the preliminary operations A and
B, the mixer can be used to control the shower manually.
Cascade
This feature offers the pleasant sensation of a waterfall lapping over your shoulders and body as you are comfortably seated.
To start the cascade, carry out the preliminary operations A and B previously described. Now proceed as follows:
D. Press the cascade button 4 on the display (Fig. 2) to start water delivery from the nozzles above the seats. To stop the
cascade, press the same button again. The green light above the button turns off when the flow of water stops.
(X) - Diverter
(Y) - Mixer
Electronic
functions
Hand
shower
Outlet
under
seat
12
11
10
9
ON/OFF buttons
for the jets group
Hydromassage
start button (6)
Shower start
button (5)
Cascade start
button (4)
Steam program
start button (1)
(2)
(3)
(8)
(7)
steam
operating time
Cycle
speed
Steam low
water
indicator (13)