Jacuzzi J-D300 Operator's Manual

Manual is about: Pool Cleaning System

Summary of J-D300

  • Page 1

    Limited warranty terms & conditions 1 year warranty coverage, exclusions apply j -d300 pool cleaning system operator’s manual contents safety and warnings 1 general information 2 tips for usage 3 assembly instructions 4 exploded parts list 5 diaphragm 7 in-pool installation 9 warranty information 13...

  • Page 2

    Suction hazards and drowning risks moving parts stop pump cleaner must be completely disabled by turning off the pool’s pump and suction before cleaning or maintaining the cleaner. Moving parts and suction can injure fingers or body. ⚠ ⚠ if your pool is equipped with one, you must cover your dedicat...

  • Page 3

    Tips for usage assembly instructions this pool cleaner was made to assist you in keeping your pool clean and well maintained. Here are ten important tips: 1. Once installed, your cleaner is designed to run for 4-6 hours and should be able to clean an average sized pool in that time. 2. Your pool nee...

  • Page 4: Jacuzzi

    Pool cleaning system parts list cleaner body assembly hose and pool connection 1 hose connector 16 automatic regulator valve 2 bumper ring 17 hose weight 3 plastic ring 18 elbow connectors 4 chamber assembly 19 intake adaptor 5 left cleaner body 20 hose protector sleeve 6 right cleaner body 21 (11) ...

  • Page 5

    Diaphragm cleaning diaphragm replacement your cleaner’s diaphragm (#15) may become clogged or damaged over time. If you notice decreased performance, check the diaphragm for debris or damage. 1. Remove the cleaner from the pool and unhook the hose from the top of the 2. 3. 4. If the diaphragm is dir...

  • Page 6

    In-pool installation 1. Make sure the pool is generally clean, free from debris, and the entire pump and troubleshooting tip: if your cleaner does not have enough power, stays in one area, or does not move at all, clean the pump and filtration system. 2. Troubleshooting tip: if one area of your pool...

  • Page 7

    In-pool installation in-pool installation skimmer intake installation 6. Troubleshooting tip: if your cleaner stays at the surface or pulls in air from the surface, install or check the automatic regulator valve. 7. 8. 9. Troubleshooting tip: if the return line pushes the cleaner away from that area...

  • Page 8: In-Pool Installation

    In-pool installation cleaner body assembly quick use guide cleaner body assembly hose and pool connection 1 hose connector 16 automatic regulator valve 2 bumper ring 17 hose weight 3 plastic ring 18 elbow connectors 4 chamber assembly 19 intake adaptor 5 left cleaner body 20 hose protector sleeve 6 ...

  • Page 9: Safety, Tips and

    Troubleshooting tips for usage moving parts suction and drowning risks safety, tips and troubleshooting stop pump before swimming. The moving pool cleaner, hose, and suction ports can injure or entrap swimmers. Stop pump , detach hose, and move the cleaner and hose to an unused corner of the pool. I...