Jacuzzi J-D300 Operator's Manual - page 7
IN-POOL INSTALLATION
IN-POOL INSTALLATION
SKIMMER INTAKE INSTALLATION
6.
TROUBLESHOOTING TIP: If your cleaner stays at the surface or pulls in air
from the surface, install or check the automatic regulator valve.
7.
8.
9.
TROUBLESHOOTING TIP: If the return line pushes the cleaner away from
that area of the pool, adjust or install an eyeball diverter.
11
12
If you are using the
skimmer intake,
then install the
automatic regulator
valve (#16)
by pulling on the threaded section of the valve until it comes away
from the main part of the regulator valve. Screw this threaded section into the
skimmer intake port. Snap the rest of the automatic regulator valve into the
threaded section.
Connect
the elbow connectors (#18)
to each other so they angle the hose
out the skimmer door, then slide the female end over the top of the Automatic
Regulator Valve.
Slide the
hose protector sleeve (#20)
over the hose where the hose will
meet the side of the pool at the skimmer opening. This will protect the
pool wall and skimmer door from the agitation of the hose.
Attach the hose to the cleaner’s top, lower the cleaner into the pool, feeding
the hose slowly into the pool so that it can fill with water, and attach the
female end through the skimmer to the elbow connector. Make sure there is
not excessive air in the hose: the hose should mostly sink. Turn the pump
on and make sure the system runs smoothly.