Jacuzzi J-DREAM Owner's Manual - J-Dream
J-Dream
™
Owner’s Manual
4
Electrical requirements
Your J-Dream, as it comes from the factory, requires a GFCI protected 240 VAC 3- wire 20 AMP 50-60 Hz circuit (2
conductor with ground) for single (1) phase electrical service, and must be in a separate circuit having no other
appliance connected in that circuit. If you do not have this kind of circuit, a qualified electrician should be called in to
install the necessary wiring. Inadequately sized wiring or locating the unit too far from the main service panel may cause
a voltage drop. A drop in voltage can cause the unit to malfunction and bring about permanent damage to the shower's
electrical system. The circuit ground wire must be provided to take advantage of the designed-in safety features of
the J-Dream. Bond according to procedure described on page 23. Caution: Without proper grounding and
bonding, a system malfunction may cause fatal shock.
Electrical precautions
Lighting and electrical receptacles must be located at least 5 feet (1.5 meters) from the J-Dream. Lighting located
between 5 feet and 10 feet (1.5 meters and 3 meters) from the J-Dream must be on a circuit protected by a GFCI.
Do not use electrically connected devices, such as television, radio, telephones, stereo speakers, lights or cooking
devices within 5 feet of the J-Dream while it is in use.
Ventilation
Water which drips on the floor during exit from the J-Dream may cause a walking hazard and/or structural damage
unless proper waterproof building materials are used in the area surrounding the unit. Take into consideration, also,
the high room humidity which will exist due to use of the steamer. Providing natural or forced ventilation of the room
will help maintain comfort and minimize moisture damage to the building. Jacuzzi Whirlpool Bath is not responsible
for damages resulting from excess moisture or water spillage. Consult an architect or engineer for aid in designing your
installation.
Maintenance
Cleaning the J-Dream
™
To clean your J-Dream, simply use a mild nonabrasive liquid detergent or commercially prepared bathtub cleaners.
Do not use abrasive cleaners. Protect and restore the gloss to a dulled surface by applying a plastic polish specifically
designed for use on acrylic finishes (methylmethacrylate). If an acrylic polish is not available, an automotive paste wax
will do.
Repairs to the surface
Minor scratches which do not penetrate the color finish (acrylic) can be removed with 600-grit wet/dry sandpaper.
Restore the glossy finish with an acrylic polish or a comparable automotive paste wax. Major scratches or gouges
which penetrate the acrylic surface will require refinishing. Ask your dealer for special instructions.
J-Dream
™
packing
Six (6) cartons packed together on a wooden palette.
Contents of cartons
• Wall Panels
• Door Frame
• Base/Cover (includes product accessory pack and owner’s manual)
• Back wall
• End Panel
• Equipment/Seat Wall