Jacuzzi Platinum Series Owner's Manual - Operation
www.clearcreekspas.com
OPERATION
Control Panel
The control panel is easy to use with fingertip control of all the spa's functions. Control of temperature, jets, blower,
filtration and spa light is readily accessible at your fingertips.
PROGRAM LIQUID CRYSTAL
DISPLAY
WARM TIME LIGHT
•
LOW
••
HIGH
•••
OFF
MODE COOL JETS BLOWER
Temperature Controls: When
either of these buttons is pressed
once, the display will show the
temperature that has been set, in
addition to the words SET HEAT. Each time either of
these buttons is pressed again, the set temperature will
increase or decrease in increments of 1°F depending on
which button is pressed. After 3 seconds, the display will
automatically show the current spa water temperature.
Jets Control: Press this button once to
activate the low-speed jet operation. Press
again to start the high-speed jet operation,
and again to turn OFF the jets. The low-
speed will start automatically when the heater is turned
ON or when a filter cycle is activated. If automatic
activation occurs, the low-speed cannot be turned OFF
with the jets button; however, the high-speed may be
started. When a freezing condition is detected, high
speed jets are automatically activated.
Whenever the low-speed is started with this button, it
will automatically stop after 4 hours of operation. The
high-speed automatically turns off after 30 minutes.
Blower: Starts or stops the blower for
aeration in the spa.
The blower will also automatically stop
after 30 minutes of operation.
Light: Press the button once to activate the
highest setting, again for the medium setting
and again for the lowest setting. A fourth
press of the button will turn the light OFF.
The light automatically turns OFF after 4 hours of
operation.
Time: Press to display time of day, press
again to display temperature. Current spa
temperature display will automatically resume
after five seconds.
Program Function: Initiates time setting,
filter programming, and panel lock routines.
Mode Function: Switches spa operation to
either the economy or standard mode. In the
economy mode, the spa will heat only during
the filter cycles and only when the water
temperature is 20°F below the setpoint. In the standard
mode, the spa will continuously heat to the set tempera-
ture.
Liquid Crystal Display
Continually shows operating
status of the spa, as well as the
various monitoring functions
and programming information.