Jadis I-35 Owner's Manual - page 8
of
12
Tubes position
First of all, remove the grid which protects the tubes sockets (be sure
the mains connector is unplugged).
Attention: For mounting the tubes, do not force them, this may
damage the sockets. Be careful at dressing power tubes (A, B, C and D)
because they have stop pins on the central parts of the mounting base.
Mount first the regulator tubes ( 1, 2, 3, 4 and 5) then mount the
power tubes. The tubes placement is shown at the top of this page.
Replace the grid and never remove it when the amplifier is
connected to the mains voltage, whether it is running or not.
IR sensor
(if equiped)