Jamara 50 7550 User Manual - Bild Fehlt
8
Bild fehlt
DE - Laden des Fahrakkus
A
Akkupack
B
Balancer
C
Ladegerät
D
Steckdose
1. Entfernen Sie den Splint seitlich am Batteriefach und ziehen
den Sicherungsstift heraus.
2. Öffnen Sie den Batteriefachdeckel und trennen die
Verbindung zum Modell. Entnehmen Sie nun den Akku.
3. Stecken Sie das Steckerladegerät in die Steckdose (D) und
klemmen Sie den Balancer (B) an das Steckerladegerät (C)
und daran den Fahrakku (A).
4. Die grüne LED (F) zeigt an dass das Ladegerät bereit ist.
Die rote LED (E) zeigt an das der Akku geladen wird. Wenn
die rote LED erlischt ist der Akku geladen.
Sollte eine der
LED´s dauerhaft blinken besteht ein Problem mit dem
Akku. In dem Fall sollten Sie den Akku überprüfen lassen
und gegebenenfalls austauschen
.
Die durchschnittliche Ladedauer des leeren mitgelieferten Akku´s
liegt bei ca. 3 - 4 Stunden.
GB - Charging the battery pack
A
Batterypack
B
Balancer
C
Charger
D
Houshold outlet
1. Remove the split on the side of battery compartment and
pull the lock pin out.
2. Open the battery compartment cover and disconnect the
connection from the battery to the model. Now remove the
battery.
3. Plug the charger into a mains socket and plug the Balancer
into it and then the battery pack.
4. The green LED (F) indicates that the charger is ready. The
red LED (E) indicates that the battery is charging. The
red LED shows that the battery is fully charged.
If any of
the LEDs are flashing permanently, there is a problem
with the battery. In that case, you should check the
battery and replace it if necessary.
The charging time by completely discharged battery pack about
3 - 4 hours.
A
B
C
D
E
F
Splint
Clips
Sicherungsstift
Lock pin
1
3
2
4