Jamara E-Rix 450 Instruction Manual - Connecting The Receiver
6
Check the stearing reaction of the helicopter precisely.
Connecting the receiver
Bat
CH6
Rollservo 2
CH5 Gyro
CH4 Rear
CH3 Throttle
CH2 Nick
CH1
Rollservo 1
Gyro Connection Instruction
1 Stroke Adjustment
2 LED Indicator
3 Sensitivity Adjustment
4 Digital Mode Option Switch
5 Servo Direction Switch
6 Connect to receiver sensitivity
channel (connect CH5)
7 Connect to receiver rudder channel
(connect CH4)
8 Connect to receiver tail rudder
1
2
3
4
5
6
7
Assembly of gyro
For best performance of the gyro, please follow the steps below:
1. Even though the gyro is very well protected from vibrations, it
still has to be placed in the helicopter so that most vibrations are fil-
tered. Otherwise the gyro might not work correctly. Check regularly
if the gyro is still secure in its position.
2. Make sure the connections are not tight or tense. Use the dou-
ble-sided tape provided.
3. When you assemble the gyro into the helicopter, make sure the
gyro has no direct contact to metal parts. The casing does protect
from electromagnetic waves and is also conductive.
4. When you assemble the gyro, make sure it is placed so that it
has a 90° angle to the yaw axis (see image).
5. Even though the gyro is protected from variations of tempera-
tures, it should not be assembled near a heat source. The neutral
position could be influenced. For example, if you decide to fly your
helicopter in the winter, make sure you let the helicopter adjust to
the temperatures outside. If you take your helicopter out of the
warm car or your warm house and do not let the gyro adjust to the
outside temperatures, the neutral position
could be influenced. Adjusting the gyro to
temperatures will take approx. 10min.
6. After switching on the helicopter, the gyro has to be initialised.
This will take approx 3 sec. In this time, no stick or lever should be
moved.
8