James Ultra 8050D-H User Manual - page 8
6
Operating instructions
How do I use the Ultra 8050D-H cleaner?
To avoid causing permanent damage: Never operate the unit without
water in the cleaning tank. Never use boiling water.
Open the lid. Place the items to be cleaned on the
1
tray (supplied) and place the tray in the tank.
2
3
To avoid the possibility of scratches from
friction during operation, do not overlap
items. Ensure items are spaced apart.
Add warm tap water (ideally 45 to 50
O
C - this
helps the unit achieve maximum cleaning potential
more quickly) in the stainless steel tank, ensuring
that the items and tray are covered but the water
level is between the “MIN” and “MAX” marking. Do
not exceed the “MAX” marking on the inside of the
tank.
Close the lid and ensure your hands are dry. Plug
the supplied mains cable into the unit and then
into the nearest mains outlet.
When the unit is plugged in, the display will show
the 180 second (3 minute) setting. If a different
time is required, press the SET button to cycle
the time through the five settings 180s 280s
380s - 480s - 90s. Move to the next step when the
display shows your required time.
Press the ON button to start cleaning. The green
operation indicator will illuminate while the unit is
in operation. The built in timer will count down the
time automatically.
When the timer counts down to 0 0 0 the unit will
automatically stop. If required, you can press
the OFF button at any time to stop or pause the
cleaning process. Press the ON button again to
resume cleaning and continue the countdown.
When cleaning has finished, you can press the ON
button again to repeat the process.
Note: During operation the unit will “buzz”, this is
normal.