Jancy Engineering Slugger USA5 Operator's Manual - page 7
Remove all contents from packaging and inspect to ensure no damage was incurred during shipping. Your USA5 package
should also include the following:
contents
of
package
description
part
#
qty
OPERATOR'S MANUAL
LIT104
1
PRODUCT DVD
LIT032
1
WARRANTY CARD
0070342
1
3/16" PILOT, 1" DEPTH OF CUT
16001
1
3/16" PILOT, 2" DEPTH OF CUT
16002
1
1/4" PILOT, 1" DEPTH OF CUT
16003
1
1/4" PILOT, 2" DEPTH OF CUT
16004
1
1/4" PILOT, 3" DEPTH OF CUT
16005
1
3/8-24 X 5/16" FPSSS
UH1474
3
3/16" HEX WRENCH
UH8013
1
3/16" T-HANDLE HEX WRENCH
UH8014
1
4MM HEX WRENCH
UH8002
1
SPOKE HANDLE
0151333
3
SAFETY STRAP
U11005
1
PIPE HANDLE
0010224
1
PIPE HANDLE ADAPTER
0010225
1
MAGNET WARNING NOTICE
0107D0C
1
SHUNT (ATTACHED TO HANDLE)
UH5335
1
SHUNT INSTRUCTIONS
U14102 1
getting
started
what
you
should
know
before
you
drill
CAUTION!
always
disconnect
usa5
from
power
source
before
making
adjustments
.
NOTE: The item numbers found below in parentheses refer to the images on page 12.
Assemble three spoke handles (item #18) to hub pinion shaft (item #17). NOTE: Feed hub assembly is mounted on
right side of machine frame . If necessary, it can be reversed for lefthand operation by simply removing the fastener (item
#29) and sleeve (item #30) from frame. Remove hub pinion shaft from right side of frame and insert it into left side of
frame. Replace sleeve and fastener into frame and tighten securely. Thread pipe handle (item #2) into motor housing.
The control panel (item #27) may also be reversed from left to right side of machine if desired. Remove screws (item
#19) holding control panel and side cover plate (item #20) next. Remove side cover plate and control panel, then
disconnect magnet and motor pin connections when removing control panel. Move control panel to opposite side of
frame. Reconnect magnet and motor pin connectors and secure control panel assembly using four screws (item #19).
Replace side cover plate, making sure warning instructions are visible.
1. Type of material to be drilled, Brinnell or Rockwell hardness, material thickness and position should all be determined
to ensure proper selection of Slugger® cutting tools, RPM, coolant and drilling time.
2. Remove any excessive mill scale or rust from surface to be drilled.
3. When drilling materials under 3/8" thick, an additional steel plate may be required to achieve proper magnet
adhesion.
4. Material that has been flame cut may have become heat-treated and therefore difficult to drill. Avoid drilling near
such areas whenever possible.
5. Drilling with the USA5 in horizontal positions requires a special lubrication for Slugger® cutters.
Consult Jancy Engineering for details.
7