Jandy AquaPalm Installation And Operation Manual - Remote Operation
Page 9
NOTE The default setting for Hotkeys 1 and 2 are AUX1
and AUX2 respectively. However, these buttons
can be assigned to any piece of equipment or
OneTouch Mood setting.
6. On the AquaPalm Handheld Remote display
screen, a prompt will appear with instructions
to slide the J-box Learn Switch out of LEARN
(OFF) and to press the J-box Reset Switch
(see Figure 8).
Figure 8. Tranceiver J-box PCB Learn Switch
MAIN CONNECTOR
RESET
D2
D3
LE
A
R
N
Y B R
G
O
F
F
O
N
LE
A
R
N
O
F
F
O
N
Transceiver
PCB
Reset Switch
Learn
Switch
Shown
in Learn
Mode
- Switch
Position
On.
Green LED
(Receive)
Red LED
(Send)
7. At the PCB in the Transceiver J-box, slide the
Learn Switch out of LEARN (ON) and press
the Reset Switch. The Red and Green LEDs
on the J-box will blink simultaneously (see
Figure 8).
Section 4. AquaPalm Handheld
Remote Operation
4.1
Basic Functions
Use the AquaPalm Handheld Remote to turn your
pool/spa equipment on and off in one of the following
ways:
1. Activate the main equipment on the front
screen by highlighting the selection, then
press SELECT.
2. Activate the equipment manually through the
EQUIPMENT ON/OFF menu.
3. Use the Hotkey buttons 1 or 2 (see
Figure 9). See Section 5.13 for a detailed
explanation of how to program Hotkeys 1
and 2.
2
POOL
ON
ON
OFF
OFF
1
select
back
AIR
78°
80°
POOL MODE
POOL HEATER
SPA MODE
SPA HEATER
MENU
EQUIPMENT ON/OFF
FRI 10:30 PM
AquaPalm
Figure 9. AquaPalm Handheld Remote Buttons
BACK
Button
UP
Button
DOWN
Button
SELECT
Button
HOT KEY 1
HOT KEY 2
Power ON/OFF
Button
Default
Screen
4.2
Using the Buttons
Use the buttons as explained in Figure 10.
Up/Down
Arrow
(Scroll)
Keys
Returns to
Previous Screen
1
2
select
back
AIR
POOL
78˚
80˚
POOL MODE
POOL HEATER
SPA MODE
SPA HEATER
MENU
EQUIPMENT ON/OFF
ON
ON
OFF
OFF
FRI 10:30 PM
AquaPalm
Selects
Highlighted
Item
Hotkeys
1 and 2
Power
ON/Off
Figure 10. AquaPalm Handheld Remote Buttons
Function