Jarvis Buster IV Operation Instruction Manual - page 2
safety messages to employer
and safety director
page 2 of 16
Model Buster IV
®
JARVIS
6206001;:
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA E--MAIL. jarvis.products.corp@snet.net
TEL. 860-347-7271 FAX. 860-347-6978 WWW.jarvisproducts.com
1. Follow our installation and maintenance instructions for proper installation and care of the tool.
2. Ensure that all employees who use this tool are trained in the proper use of this tool and are aware of
the dangers that may arise if they do not follow the procedure outlined in this brochure.
3. Enclosed are four (4) copies of
“NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP
PERSONNEL.”
Post one copy on the employees’ bulletin board; give one copy to the operator(s); give
one copy to the maintenance foreman; and give one copy to the sub-contract cleanup / internal cleanup
foreman. Additional copies will be provided upon request.
4. The tool is designed and intended to be powerful. This fact should be obvious to your employees, but
you must emphasize it to them.
5. Ensure that proper procedures are established in accordance with OSHA’s lockout/tagout procedures
(29 CFR 1910.147) to prevent accidental startup or release of stored energy.
6. Remove and repair any tool that malfunctions. All personnel must be instructed to remove any
malfunctioning equipment.
7. Never make modifications or alterations to the tool. Replace any missing or illegible labels.
8. Avoid injury. Do not permit the tool to be misused.
9. If you resell or distribute a Jarvis product, you must provide the purchaser with the appropriate safety
sheets and tool brochure. Additional copies of safety sheets and tool brochures will be provided upon
request.
SAFETY MESSAGES TO EMPLOYER AND SAFETY DIRECTOR
AVOID INJURY
Keep hands clear.