Jarvis Buster IV Operation Instruction Manual - page 3
safety messages to operators,
maintenance and cleanup personnel
page 3 of 16
Model Buster IV
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457--4926
UNITED STATES OF AMERICA E--MAIL. jarvis.products.corp@snet.net
TEL. 860-347-7271 FAX. 860-347-6978 WWW.jarvisproducts.com
®
JARVIS
6206001;:
1. Never put fingers, hands or other parts of the body on the cutting edge or within the cutting path of the
tool when it is connected to the power supply.
2. Disconnect the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before making any blade changes.
3. Disconnect the power supply in accordance with OSHA’s lockout/tagout procedures (29 CFR
1910.147) before performing any repairs or maintenance.
4. Disconnect the power supply -- or have the power supply disconnected -- in accordance with OSHA’s
lockout/tagout procedures (29 CFR 1910.147) before performing any cleanup.
5. Disconnect the power supply when the tool is not in use.
6. Test the tool prior to use or daily. Depress one trigger, then pause one second and depress the other
trigger and the tool should not start. Repeat this procedure reversing the triggers. Depress both triggers
simultaneously and the tool should start. With the tool running, release one trigger and the tool should
stop. Continue holding the depressed trigger and then depress the other trigger. The tool should not
start. Repeat this procedure holding the other trigger. If the tool malfunctions, remove it from service
and report or repair it immediately.
7. Never depress the triggers unless you want to use or test the tool.
8. Never make modifications or alterations to the tool. Report or replace any missing or illegible labels.
SAFETY MESSAGES TO OPERATORS, MAINTENANCE AND CLEANUP
PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
Keep hands clear.