Jasic MAG SERIES Operator's Manual - page 13
Multifunctional display window
During welding, the current display window displays the
practical welding current value, and the voltage display
window displays the practical welding voltage value. In
standby mode, the windows display as follows.
*-It displays VRD voltage when not turning the voltage
control knob, and displays the arc force when turning the
voltage control knob.
System parameters setting
This machine uses a group of welding parameters in
common use as default. If the user wants to alter these
parameters, he or she can realize this by altering the system
parameters.
The method to alter the system parameter is as follows:
1)
Press the 2T/4T switch key on the panel and do not
release it. Then, turn on the power switch of the welding
machine.
2)
When the display window displays “--- ---“, release
the 2T/4T switch key to enter into the system parameter
adjusting interface.
3) Select the welding mode which needs adjusting by turning
the welding mode select switch, select the parameter
number through the current control knob, and select the
parameter value through the voltage control knob.
Please refer to the table below for the contents of system
parameters.
4)
After the parameter adjustment is done, press the 2T/
4T switch key again to store the system parameters. Then,
the machine enters into standby mode.
For welder training please visit our Academy website at
www.wilkinson-welding-academy.com
12
Welding mode
Current display
window
Voltage display
window
MMA
Preset current (A)
VRD voltage (V)/
arc force (A/MS)*
MIG (including
unified adjusting)
Preset wire feed
speed (m/min)
Preset voltage (V)
TIG
Preset current (A)
Downslope time (s)
MMA
MIG
TIG
P1
Ignition current (A)
Crater filling speed (m/min) Initial current (A)
P2
Ignition time (s)
Crater filling voltage (V)
Pilot arc current (A)
P3
Capacity setting (A)
Downslope time (s)
Upslope time (s)
P4
Return to the default
parameter (0: No; 1: Yes)
Pre-flow time (s)
Pre-flow time (s)
P5
Post-flow time (s)
Post-flow time (s)