Javes XPL-520 User Manual - Adjusting The Focus
- 8 -
suspender of projector. When setting projector’s position, to make sure decrease distortion,
please put the projector to the place of vertical line of screen as close as you can.
Aberrances of projector and vertical line of screen are more than 30 degree may cause
distortion.
Section 4 Adjusting Picture Quality
Adjusting the focus
Circumvolve the focus ring until focus is ok and picture is clear.
Notice:
It is not able to focus when the lens is dirty or wet. Please clear the feculence.
If the distance of project is out of range, it will be not able to focus. If it is hard to get correct
focus, please confirm the distance of projection.
Chapter 3 Advanced Operations
Section 1 Signal Selected
It will hereby introduce how to use the menu to operate various advanced operation as
below.
Under the situation of menu off, Press the “PC/AV” button of projector or remote control
to choose the signal of one of the VIDEO, S-VIDEO, VGA or TV. It is the same no matter you
operates at projector or remote control.
Signal: press “PC/AV” button to get “PROGRAM” menu.
VGA Computer
HDMI High Definition Signal
YPbPr YPbPr Signal
VIDEO Video Input
S-VIDEO S-video Input
TV (optional) TV Input
Section 2 OSD
This projector has the following menus: PICTURRE, DISPLAY, TV (with TV input), and
VGA (with VGA input). Each of these menus is operated using the same methods. The
images and basic operations of these menus are as follows:
1. Picture
Use the buttons ←/→ to select an item to operate, and then press ↑/↓ to operate.