Jay-tech Combo-Scanner PS970 User Manual - 4. Loading Slides

5

4. Loading Slides

Hold up the slide toward the light. Face the

trademark side of the slide away from you.

Look through the slide and it should appear

normally (not a mirror image).

Now turn the slide so the image is upside

down while looking at the same side.

Open the slide holder at the marked spot on

the top.

With the slide holder laid open place the slide

into recessed area in the holder- the slide

should fit perfectly.

Note:

 Handle slides with care. Any dust

scratches or fingerprints will show up on your

saved images. If possible use cotton gloves when handling slides. It is

recommended to use compressed air to remove any dust on the slides. This

is not included with the Combo-Scanner but can be purchased from an

office supply or electronics retailer.

Close the slide holder and press the edges

so that it locks in place.

Hold it in the position as shown in the

Combo-Scanner.

Insert the Slide Holder into the slot on the

right side of the Combo-Scanner as shown.