Jay-tech Combo-Scanner PS970 User Manual - 5. Loading Negatives

6

5. Loading Negatives

Hold up the negative toward the light. As you

look through the negative you should be able

to read the small negative numbers normally

(not a mirror image).

Now turn the negative so the image is upside

down while looking at the same side.

Open the negative holder at the marked spot

on the top. With the negative holder laid open

place the negative into holder so the notches

line up with the notches on the holder.

Note:

 Handle negatives with care. Any dust,

scratches or fingerprints will show up on your

saved images. If possible use cotton gloves when handling negatives. It is

recommended to use compressed air to remove any dust on the negatives.

This is not included with the Combo-Scanner

but can be purchased from an office supply

or electronics retailer.

Close the negative holder and press the

edges so that it locks in place.

Hold it in the position as shown in the

Combo-Scanner. Insert the negative holder

into the slot on the right side of the Combo-

Scanner as shown.

Film Holder:

 The design of film holder is

follow ISO standard. In some cases the holes

on the film will not match exactly to alignment of the holder. This is caused by

a non-standard camera. In this case there will be a small black line on the

edge of the frame that can easily be cropped out using photo editing software.

ISO

 - International Organization for Standardization